Uniden XCA650 important safety instructions Setting the Handset Retainer

Page 19

8.Plug the AC Adapter into a standard 120V AC wall outlet.

Note: Do not use an outlet controlled by a wall switch.

Use only the Uniden AC Adapter supplied with this phone.

Setting the Handset Retainer

The Handset Retainer holds the Handset in place if your phone is mounted on a wall. The steps below describe how to remove and replace the retainer so that the tab faces up.

1.Push up on the Handset Retainer on the Base Unit, and slide the tab out.

25 CHANNEL

2.Flip the retainer over so the tab faces up.

25 CHANNEL

19

Image 19

Contents Contents Page Important Safety Instructions Battery Safety Precautions Introduction FeaturesIncluded with the XCA650 Important Electrical Considerations Telephone Line ProblemsRange More Than One Cordless Telephone Radio InterferenceSelecting a Location InstallationTelephone Line Outlets Applying Power to the Base Unit Connecting the Telephone CordsDesk or Tabletop Installation Adapter Safety FeatureRing VOL PULSE-TONE DC OFF-LO-HI Use only the Uniden AC Adapter supplied with this phone Wall Installation Standard Wall Plate Mounting Plug the AC Adapter into the Base Unit Direct Wall Mounting Ring VOL PULSE-TONE DC OFF-LO-HI Place the AC Adapter cord inside the molded channel Setting the Handset Retainer Put the retainer back into its slot on the Base Unit Installing the Handset Battery Pack Setting Up Your PhoneExtending the Antenna Page Cleaning the Battery Contacts Charging the Battery Pack Initial Battery Charging Battery Memory Effect Low Battery IndicatorSetting the Pulse/Tone Switch Base Volume Controls Adjusting Ringer/Volume Controls Handset Ringer ControlAutomatic Digital Code Security Page Page Making and Receiving Calls Using Your PhoneChannels Changing Channels, Flash, and Page/FindStoring a Number in Memory Programming Your PhoneService, press P Storing a Mixed Number 3300 Dialing a Stored Number Erasing a Stored Number Chain DialingTone indicates the number is Erased Integrated Answering System Turning the Answering System On/Off Handset Operation Answering System SetupTo turn the Answering System Off, press R Base Operation Setting the Clock30320# Reviewing Time and Day Stamp Handset Operation Preset Messages Setting Your Outgoing Message OGMRecording Your Personal OGM Handset Operation Message replays in the Handset receiver Base Operation Selecting a Preset OGM Setting the Toll Saver Switch VOX/Calling Party Control FeatureUsing the Reset Button Playing New Messages Handset Operation Using Your Answering SystemTalk/batt low LED goes off Playing a Stored Message Handset Operation First message stored begins playing Repeating a Message Handset Operation To return to Standby, press R Base Operation Skipping a Message Handset Operation To return to Standby Press R Deleting a Message Handset Operation If you decide to delete a Message, press 4during the message Deleting All Messages You will hear three short tones, followed by a longer tone Voice-Guided Help Menu Message Full IndicationWhen you return to Standby, the talk/batt low LED goes off Screening Incoming Calls Leaving a Memo Message To record a conversation during a call Recording a Telephone ConversationRemote Operation Setting Your PIN CodePress R again to return Using a Touch-Tone Phone Your Answering System automatically returns to Standby Telephone Troubleshooting Chart TroubleshootingAll of the saved messages Answering System Troubleshooting ChartPage XCA650/655 Precautions Answering Device Remote Keys Handset Controls and Keys Base Unit Controls and Keys One Year Limited Warranty