If the talk/batt low LED begins to flash, the phone is programmed to limit its functions to save power. The table below describes what to do to return your phone to normal operation.
DURING A CALL | IN STANDBY MODE |
|
|
Only the Abutton operates. | None of the buttons will operate. |
The Handset beeps and the talk/batt | The Handset talk/batt low LED flashes |
low LED flashes once every 3 seconds. | once every 3 seconds. |
|
|
Complete your call as quickly as | You will not be able to make a call. |
possible. |
|
|
|
Return the Handset to the Base Unit for | Return the Handset to the Base Unit for |
charging. | charging. |
|
|
Note: Allow 15 to 20 hours without any interruption for the Handset to fully recharge.
Setting the Pulse/Tone Switch
Be sure the PULSE/TONE switch is in the TONE position.
Note: Most phone systems are Tone dialing. Check with your local phone company if you are not sure whether your system is Tone or Pulse dialing.
26