Uniden EXAI2980 Changing the Digital Security Code, Installing the Beltclip Headset Installation

Page 34

EXAI2980A ReSIZE-ENG 7/31 7/31/01 16:50 Page 32

If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is

Changing the Digital Security Code

The digital security code is an identif ication code used to connect the handset and the base unit. Normally, set- ting the code is not necessary.

The first time you charge your handset, the security code is automatically set. (See "About the digital security code", page 5.) In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.

1)Remove the handset from the base unit. Press and hold page on the base.

2)While the handset is emitting the paging sound, place the handset on the base unit holding page. The paging sound stops.

Leave the handset on the base for more than 5 seconds or until flashing stops. A new random security code is set.

charged.

Installing the Beltclip

Headset Installation

If the beltclip is attached, you can only charge the handset in the face down position.

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the belt- clip to release the tabs from the holes.

Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert headset plug into the headset jack. Your phone is ready for hands-free conversations.

(Headset may be purchased by calling the Uniden Parts Department or visiting the web site. See Page 4.)

[ 32 ] A D D I T I O N A L I N F O R M AT I O N

Image 34

Contents R D L E S Welcome Features Contents Controls and Functions N T R O L S a N D F U N C T I O N S Checking the Package Contents Read this FirstSetting up the Phone Do the following stepsBattery use time per charge Low battery alertCleaning the battery charging contacts Wall outletChoose the dial mode Standard wall plate mounting Setting the handset retainer clip for wall mountingMounting the Base Unit on a Wall Direct wall mountingEntering Your Area Code Setting Caller ID Options/LanguageTo change your Caller ID options/Language Making and Receiving Calls Press talk Listen for the dial tone Press redial/pTerminology Adjusting the Handset Ringer and Earpiece VolumeTone Dialing Switch-over RedialSelecting a Different Channel Traveling Out-of-RangeFlash and Call Waiting Storing Phone Numbers and Names Steps for Entering Names and Special Characters If you make a mistake while entering a nameMaking Calls with Memory Dialing StandbyChain Dialing Editing a Stored Name and/or Phone NumberErasing a Stored Name and Phone Number 7Press select or deleteWhen the Telephone Rings Caller IDDeleting a Caller ID message Viewing the Caller ID Message ListDeleting Information from the Caller ID List Deleting all Caller ID names/numbersCalling a party from the Caller ID list Using the Caller ID ListDial edit Storing Caller ID messages in Memory dialing Integrated Answering Device Turning the Answering System On/OffUsing the Menu Mode Setting up Your Answering SystemSetting Your Outgoing Message Greeting Setting the Time Adjusting the speaker volume level Setting a Personal Security Code PINSetting the base ringer volume Setting the ring timeAnnounce only feature Selecting the message record timePlaying your messages Using Your Answering SystemRepeating a Message Deleting a message Skipping a message Voice memo Remote access away from home Recording a conversationTurn on the answering system remotely Installing the Beltclip Headset Installation Changing the Digital Security CodeMaintenance General InformationTroubleshooting Additional Information Index At Uniden, we´ll take care of you