Uniden EXS 9910 manual Installing the handset battery pack

Page 13

Installing the handset battery pack

Charge the battery pack for more than 16 hours before you start using your phone.

1 Press in on the battery cover release and slide the cover down until it comes off.

2 Install the nickel-cadmium battery with the label facing down.

Label face	3 Slide the battery cover on
	3 Slide the battery cover on
	until it snaps into place.

4 Place the handset on the base.

SPDIGITA

SPECTRAMEAD L

900MHz

status LED

5 Make sure that the “status” LED lights. If the LED doesn’t light, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts.

Use only Uniden Battery (BT-999) supplied with your phone.

10

Image 13

Contents Page Introduction FeaturesTalk Flash Controls and functions25 26 Contents Base unit Read this firstHandset Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf your dialing system is Set the switch to Tone Choose the dialing modePulse If you arent sure of your dialing systemDC in 9V jack Direct wall plate mounting Installing the handset battery pack Battery use time per charge Charging optional battery packsWhen the battery charge becomes low Cleaning the battery contactsAutomatic digital code security Other Operations Making a callHandset on the base Receiving a callHandset off the base Flash and Call Waiting Adjusting the ringer and earpiece volumeMute Redialing a callTo locate the handset while it’s off Using page featureBase, press page/find on the base Handset beeps for 15 secondsStoring phone numbers One-touch memory dialing Making calls with memory dialing Memory dialingErasing a stored phone number Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenanceSymptom Suggestion TroubleshootingGeneral SpecificationsBase unit HandsetV, W, X, Y, Z IndexJ, K, L