Uniden TRU 341 owner manual Installation, Charging the Battery Pack

Page 7

Installation

Charging the Battery Pack

The rechargeable nickel-cadmium battery pack must be fully charged before using your phone for the first time. Before plugging the phone line into your new phone, you must charge the battery for approximately 15 hours without interruption.

1. Remove the handset battery cover.

2. Plug the battery cable into the handset and place the battery pack inside the battery compartment.

3. Replace the battery cover.

▼Charging the Handset

To charge, place the handset on the base as shown with the keypad facing forward.

•The plastic connectors will fit together only one way. Make sure the battery´s connector is properly aligned.

Use only the Uniden battery pack (model BT-905).

•Replacement batteries are also available through the Uniden Parts Department. (See page 3)

I N S TA L L AT I O N

I N S TA L L AT I O N [5 ]

Page 6 Page 8
Image 7
Page 6 Page 8
Contents N E R ’ S M a N U a L Contents Features Recycling NICKEL-CADMIUM Batteries Also included Included with Your TRU 341 PhoneControls and Functions Charging the Battery Pack InstallationBattery use time per charge Avoid microwave ovens Selecting a LocationSetting the Dial Mode Switch Setting Up Your PhoneConnect the Base Unit Ringer Tone and Volume Adjusting Ringer/Volume ControlsMaking and Receiving Calls Using Your PhoneStoring a Number in Memory Storing Mixed Tone/Pulse Numbers Entering a Pause in Memory DialingChain Dialing Dialing a Stored NumberErasing a Stored Number Replacing a Stored Number MuteSelecting a Different Channel Using the Page/Find Feature Using the Flash ButtonTraveling Out of Range Troubleshooting Headset Installation Installing the BeltclipTo Attach the Beltclip To Remove the Beltclip AC Adapter Information Battery InformationUCZZ01715BZ
Top Page Image Contents