Uniden XC345 manual Way Paging, Paging the Base Unit, To end Conversation

Page 35

Usin~ellntercom

The 2-Way Page/Intercom feature allows you to communicate between the Base Unit and Handset. To use this feature rememberthe following:

. The RINGON/BATTSAVEswitch on the Handset must be in the RINGONposition.

. The BASEUNITRINGERswitch must be set to either LOor HI.

Note: If you are on a call while using the Handset and you page the Base Unit, the Base Unit will ring even when the Base ringer switch is set to the OFFposition.

2-Way Paging

Paging the Base Unit
1. Press~on	0
Handset.

Note:If thereis . no answer,press

~ again to cancel.

2.Press (tNT'COM)or

	(SPEAKER)on Base		3
	Unit to answer		3
	Unit to answer
	page.
	The IN USE,
	INT'COM and		2
	TALK/BATT LOW		2
	TALK/BATT LOW		1
	LEDs light.		1
	LEDs light.
	To end the
	conversation:
	3. Press ~	on the

Handset,(lNfCOM)or

(SPEAKER)on the Base.

Note: If the switch is set to BATT SAVE, the Handset will not ring if there is an incoming call. You will not be able to page or transfer a call to the Handset as well.

31

Image 35

Contents Unl. ~n@ Precautions SelectButton~ 11 DD@000Microphone MuteButton ~ withLED18 16 FlashButton ~OfContents Important Safet~ Instructions Page Introd uction FeaturesIncluded with the XC345 Im~ortant Electrical Considerations Telephone Line ProblemsMore Than One Cordless Telephone Radio InterferenceTelephone Line Outlet Selecting a LocationApplying Power to the Base Unit Connecting the Telephone CordsDesk or Tabletop Installation Page Placement of the Handset Screwheadsfor mountingthe Direct Wall Mounting==J Page Flip the retainer over so the tab faces up Setting the Handset RetainerPlace Extending the Antenna Installing the Handset Battery PackSlide the battery compartment cover down Cleaning the Battery Contacts InitialBattery Charging Charging the Battery PackCD er af Omww@mm ~ @~ Low Battery IndicatorHandset Volume Controls Adjusting RingerNolume ControlsBase Volume Controls Automatic Digital Code Security Efe «D-Uf~~r O-bmmID C5OcriD «TIn Laking and Receiving Calls Using your XC345Changing Channels Placing a Call on Hold Changing Channels, Hold, Mute, and FlashTo end Conversation Way PagingPaging the Base Unit Paging the Handset Transferring a CallTo end the conversation Transferring a Call from the HandsetPress ~ or !D on Rransferring a Call from the BaseTo turn the monitor off Room Monitor FeatureHandset Operation Storing a Number in MemoryPress~again OmQm Page Handset Operation XYZ11 ~~.~ Base Operation GJ~Jmoo0000 ~0000 Storing One-Touch Dialing Numbers XYZ@ ROUP~@@0@0@ TSase Operation 00 i-C~j -~fTone indicates that the number is stored Chain Dialing Dialing a Stored Number Handset OperationHandset Erasing a Stored NumberTroubleshooting Handset GeneralWarranty Unirl~n@