Uniden XC345 manual Troubleshooting

Page 54

Troubleshooting

If your XC345 Cordless Telephone is not performing to your expectations,

please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service for Assistance.

Problem

Charge light won't come on when Handset is placed in Base Unit.

Suggestion

. Make sure AC Adapter is plugged into the Base Unit and wall outlet.

. Make sure Handset is properly seated in Base Unit.

Audio sounds weak and/or scratchy.

Can't make or receive calls.

Handset doesn't ring or receive a page.

Base Unit doesn't ring or receive a page.

. PleasecleanboththeHandsetandBasecharging

contactswitha pencileraseror dry cloth.

. Make sure that the Base Unit antenna is

fully extended and vertical.

. Move the Handset and/or Base Unit to

different locations and try again.

. Press the CHANNEL button to select another channel.

. Check both ends of the Base Unit telephone line cord.

. Make sure the AC Adapter is plugged into the Base Unit and wall outlet.

. Disconnect the AC Adapter for a few minutes, and then reconnect it.

. Nickel-Cadmium battery pack may be weak. Charge the battery on the Base Unit for 15 - 20 hours.

. Set the RINGONlBATTSAVEswitch on the Handset to RINGON.

. Extend the Base Unit antenna vertically.

. The Handset may be too far away from the Base Unit.

. Place the Base Unit away from noise sources.

. The Digital Security Code may be erased. Set the Digital Code.

. Set the Base Unit Ringer switch to LO or HI.

Note: Do not attempt to service this unit yourself. All service must be done

by qualifiedservicepersonnel.

50

Image 54

Contents Unl. ~n@ Precautions 11 DD@000 SelectButton~FlashButton ~ MuteButton ~ withLED18 16 MicrophoneOfContents Important Safet~ Instructions Page Features Introd uctionIncluded with the XC345 Telephone Line Problems Im~ortant Electrical ConsiderationsRadio Interference More Than One Cordless TelephoneSelecting a Location Telephone Line OutletConnecting the Telephone Cords Applying Power to the Base UnitDesk or Tabletop Installation Page Placement of the Handset Direct Wall Mounting Screwheadsfor mountingthe==J Page Setting the Handset Retainer Flip the retainer over so the tab faces upPlace Installing the Handset Battery Pack Extending the AntennaSlide the battery compartment cover down Cleaning the Battery Contacts Charging the Battery Pack InitialBattery ChargingOmww CD er afLow Battery Indicator @mm ~ @~Adjusting RingerNolume Controls Handset Volume ControlsBase Volume Controls Automatic Digital Code Security Efe «D-Uf~~r O-bmmID C5OcriD «TIn Using your XC345 Laking and Receiving CallsChanging Channels, Hold, Mute, and Flash Changing Channels Placing a Call on HoldWay Paging Paging the Base UnitTo end Conversation Transferring a Call Paging the HandsetTransferring a Call from the Handset To end the conversationRransferring a Call from the Base Press ~ or !D onRoom Monitor Feature To turn the monitor offStoring a Number in Memory Handset OperationPress~again OmQm Page XYZ Handset Operation11 ~~.~ GJ~Jmoo Base Operation0000 ~0000 XYZ Storing One-Touch Dialing Numbers@ ROUP~@@0@0@ 00 i-C~j -~f TSase OperationTone indicates that the number is stored Dialing a Stored Number Handset Operation Chain DialingErasing a Stored Number HandsetTroubleshooting General HandsetWarranty Unirl~n@