Uniden UH-050XR manual To Transmit and Receive, TX appears on the LCD

Page 11

TO TRANSMIT AND RECEIVE

The UH-050XRuses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed at the end of this manual.

1.The maximum RF transmit power of UH-050XRis 5 watts.

To switch to low power, press the [1/5W]. LOW appears on the LCD.

To switch back to higher power, press the [1/5W] again. LOW indicator disappears from the LCD.

OS/GS

DUPLOCK

2.Before you transmit, listen for activity on the selected channel.

3.When the channel is clear, press and hold the [PTT] to transmit.

TX appears on the LCD.

PTT

 

switch

OS/GS

DUPLOCK

Hold the radio with microphone approximately two inches in front of your mouth with the antenna at approximately 45˚ angle away from your head. Speak in a clear, normal conversational voice.

4.When you have finished speaking, release the [PTT] and listen for a response. TX indicator then disappears on the LCD.

The display shows BUSY when a transmission is being received by your radio.

8

Image 11
Contents Operating Guide NICKEL-CADMIUM Battery Pack Warning Contents Introduction FeaturesAustralia Technical Support and ServiceIncluded in Your UH-050XR Package Attaching the Antenna Charging the Battery PackGetting Started When charging, the CHG icon appears on the display Battery Charge IndicatorSelecting Channel Power ON/OFFVolume OperationSquelch TX appears on the LCD To Transmit and ReceiveUsing a Repeater Channel Scanning To Operate UH-050XR in Duplex ModeGroup Scan GS Mode Programming Scan Channels DROP-OUT DelayPriority Channel To use monitor Power SaveBattery Level Display UHF Channels & Frequencies Optional AccessoriesReceiver SpecificationsGeneral TransmitterCharger Uniden UH-050XR UHF CB Radio WarrantyAustralian One Year Warranty Controls & Indicators OS/GS