Uniden 2300 Global Setup, Setting Name Tag POP ID, Setting Insert Zero New Zealand only

UP349BH (WDECT2300) ENG OM 5/12/04 10:53 AM Page 14

For setting the Day and Time, the idle time-out is extended to 2 minutes.

Global Setup

Setting Name Tag (POP ID)

1)Enter the Global Setup menu, and then the Name Tag submenu (see “Entering the Menu” on page 11).

2)Press /vol/ or /vol/ to change the selection, On or Off.

3)Press . You will hear a confirmation tone.

Setting Insert Zero (New Zealand only)

1)Enter the Global Setup menu, and then the Insert 0 submenu (see “Entering the Menu” on page 11).

2)Press /vol/ or /vol/ to change the selection, On or Off.

3)Press . You will hear a confirmation tone.

Setting Day and Time

1)	Enter the Global Setup menu, and then the Day & Time		Day	&	Time
	submenu (see “Entering the Menu” on page 11).
			SUN	12:00 AM
2)	Press /vol/ or /vol/	to select the day of
			[ / /	/	/SELECT]
	the week, and then press	.

3)Press /vol/ or /vol/ to set hour and then

press .

4)Press /vol/ or /vol/ to set minute and then press .

5)Press /vol/ or /vol/ to choose AM or PM, and then press . You will hear a confirmation tone.

[ 14 ]

Setting the Dial Mode (Australia only)

1)Enter the Global Setup menu, and then the Dial Mode submenu (see “Entering the Menu” on page 11).

2)Press /vol/ or /vol/ to change the select, Tone or Pulse (the initial setting is Tone).

3)Press . You will hear a confirmation tone.

Dial Mode

Tone

Pulse