UP349BH (WDECT2300) ENG OM 5/12/04 10:53 AM Page 20
•The tone feature only applies when the dial mode is set to pulse.
•This special number can be stored in a memory location. This is referred to as Chain Dialing (see page 31)
[ 20 ]
MUTE MICROPHONE
You can temporarily turn off the microphone so that the person you are talking with cannot hear you.
1)Press /del during talk mode (while phone is in use).
2)Press /vol/ or /vol/ to move the pointer to Mute and then .
Mute On and appear in the display. To cancel muting, repeat above step again when Mute is set to on, Mute Off appears.
TONE DIALING SWITCH-OVER (AUSTRALIA ONLY)
Some telephone companies use equipment that requires pulse dialing (sometimes referred to as rotary dialing). If you need to enter tone dialing digits, you can
Initially make your call with the pulse dialing mode. Once your
call connects, press . Enter the desired number. These digits will be sent as tone dialing. Once the call ends, the tone mode is canceled and pulse dialing mode resumes.
TRAVELING OUT-OF-RANGE
During a call, as you begin to move your handset too far from your base unit, noise may increase. If you pass the range limits of the base unit, you will hear a beep and see Out of Range on the display, and then the handset returns to standby mode.
You may return to the call if you move your handset within the range limits of the
base and press or speaker within 30 seconds.