Pioneer PRV-9200 operating instructions Information to User, Risk of Electric Shock Do not Open

Page 2
D8-10-1-3_EF
D8-10-3a_En
D8-10-1-2_En
D8-10-2_En
D1-4-2-6-1_En

CAUTION

The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

D1-4-2-3_En

IMPORTANT NOTICE – THE SERIAL NUMBER FOR THIS EQUIPMENT IS LOCATED IN THE REAR.

PLEASE WRITE THIS SERIAL NUMBER ON YOUR ENCLOSED WARRANTY CARD AND KEEP IN A SECURE AREA. THIS IS FOR YOUR SECURITY.

Information to User

Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

CAUTION : USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION : THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD. D6-8-2-1_En

WARNING – TO PREVENT FIRE OR SHOCK

HAZARD, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

D1-4-2-1_En

CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.

Image 2
Contents PRV-9200 Information to User Risk of Electric Shock Do not OpenImportant Safety Instructions POWER-CORD Caution Decibel Level Example To establish a safe levelOnce you have established a comfortable sound level Contents Initial Setup menu Disc Setup menuVideo/Audio Adjust menu Setting the picture quality for TV and externalBefore you start Chapter FeaturesBefore you start Before you start Before you start What’s in the box Putting the batteries in the remote controlUsing the remote control DVD-R/RW compatibility General disc compatibilityCompressed audio compatibility CD-R/RW compatibilityPC-created disc compatibility Frequently asked questionsJpeg file compatibility Before you start About the internal hard disk drive Rear panel connections Connecting upConnecting up Chapter Front panel connectionsConnecting up Easy connections VCRConnecting using the component video output Connecting up Using other types of video outputConnecting using an S-video output Connect RF antenna cables as shown This enables you to watch and record TV channelsThis enables you to watch the output from this recorder This enables you to watch discs Connecting up Connecting to an AV amplifier or receiver This enables you to listen to multichannel surround soundAfter checking all the connections, plug in the recorder Connecting up Connecting other AV sourcesPlugging Front panel Controls and displaysControls and displays Chapter Character display Channel recording indicators Play / REC indicatorsRecording quality indicators Controls and displays DisplayControls and displays Remote control Controls and displays Getting started Chapter Switching on and setting upGetting started Getting started Connected, or Not Connected, then press Enter Other settings you can makeSelecting the hard disk or DVD for playback and recording Digital, Dolby Digital, DTS or PCM only, then pressPlaying back your recording Using the built-in TV tunerGetting started Making your first recording Changing TV channelsBasic playback Changing audio channelsPlaying DVD discs Playing from the HDDPlaying CDs and WMA/MP3 discs Playing Video CDsHome menu options Getting started Using the Home MenuDisplaying disc information on- screen Play display HDD and removable disc activity displayStop display Recording display Playback Chapter Using the Disc Navigator to browse the contents of a discPlayback IntroductionChanging the thumbnail picture for a title Using the Disc Navigator with recordable discs and the HDDPlayback Use Cursor buttons to select a Title to playNavigating discs and the HDD Scanning discsSlow 1/2 Playing in slow motionFrame advance/frame reverse PressRepeat Playback Play Mode menuSearch Mode Repeat play Program playOther Program play functions Repeat to build up a program listTo switch off subtitles, press Subtitle then Playback Displaying and switching subtitlesSwitching DVD soundtracks Press Subtitle repeatedly to select a subtitle optionTo display/switch the audio channel, press Audio repeatedly Playback Switching audio channelsSwitching camera angles To switch the camera angle, press AngleAbout DVD recording RecordingRecording Chapter About HDD recordingRecording equipment and copyright Recording Recording time and picture qualityRestrictions on video recording Basic recording from the TV Recording Setting the picture quality/recording timePress REC Mode repeatedly to select a recording setting Front panel display shows the channel numberTo stop the recording, press Stop REC Setting a timer recordingRecording 12/13 MON Easy Timer RecordingTime using Buttons Cursor to the recording end time on the grid Standard timer recordingUse Recording end timeTimer recording using the VCR Plus+ programming system To exit the timer recording screen, press Home MenuVCR Plus+ programming with the power off US CodeMoving the end time by 30-minute blocks Extending a timer recording in progressCanceling and stopping a timer recording in progress Programming a new end timeSimultaneous recording and playback Timer recording FAQYou can’t enter a timer program if the clock isn’t set Press REC when you’re ready to start recording See Connecting up for connection optionsSet up the recorder Recording Recording from an external componentSee Ntsc on PAL TV on page 99 for more on these settings Recording from a DV camcorderPress Home Menu and select ‘DV Record’ from the menu Also, set the camcorder to VTR modeRecording from the DV output ‘Start Rec’ and press EnterRecording Playing your recordings on other DVD players Finalizing a discIt takes about 30 seconds to initialize the disc Press Home Menu and select ‘Disc Setup’ Select ‘Initialize’Recording Initializing a DVD-RW disc High-speed copying Copying and back-upCopying and back-up Chapter Copying and back-up One Touch Copy* HDD to DVDCopying from HDD to DVD Canceling One Touch CopyCopying and back-up One Touch Copy* DVD to HDD HDD to DVD Copy List screen appears HDD to DVD Copy List menu optionsSelect ‘HDD DVD’ Recording the Copy List HDD to DVD Copy List commandsSelect ‘Conf List’ to display the Copy List settings screen AddDivide EraseTitle Name Ttl Name Input a name for the selected titleMove CombinePreview Chapter Edit Chpt Edit Select a command from the chapter edit menu optionsErase All Chapter you want to move, then press Enter Chapter Edit MoveChapter Edit Combine Use Cursor buttons to select aErase Section Erase Sec Running time Copy List Copying and back-up Copying from DVD to HDDCurrently selected DVD title DVD to HDD Copy screen appears DVD to HDD Copy List menu optionsSelect ‘DVD Use Cursor up/down buttons to highlightCopying and back-up DVD to HDD Copy List commands HDD Using disc back-upTitle to move Copy List insertion point No Disc Please load a disc to be backed-up Start Cancel Disc Navigator screen EditingEditing Chapter HDD Disc Navigator Playback will automatically stop when you do thisEditing HDD group tabsPlaylist / Original indicator Disc Navigator menu optionsPlay Editing VR mode Original, Video mode and HDD contentVR mode Play List Select ‘Erase’ from the Disc Navigator menu optionsUsing the remote key shortcuts to input a name Key CharactersNew chapter markers Inserting chapter markers into a titleStart playback of the title you want to create New chapter to beginSelect ‘Erase Sec’ from the Disc Navigator menu options Use Command using the Undo option from the DiscLock / Unlock TitleUndo Select No if you want to cancel and leave the title intactEditing HDD groups Select ‘Undo’ from the Disc Navigator menu optionsGroup Name Grp Name Creating and editing a VR mode Play ListChange Group Chg Group Input a name for the groupList menu options EditingSelect ‘Ttl Name’ from the Disc Navigator Play Select the title you want to name, then pressLocation for it, then press Enter again Undo Undo the last commandWant to move, press ENTER, then highlight the new Preview Preview chapters Select the chapter youOriginal title to put into the Play List New title appears in the updated Play ListCreate Press Enter to add the titleMenu options This command erases all the titles from the Play ListSelect ‘Divide’ from the Disc Navigator Play List Select the title that you want to divide, thenDisc History Chapter Using the Disc HistoryDisc History Playing a slideshow PhotoViewerPhotoViewer Chapter Reloading files from a discRotating the screen PhotoViewerZooming the screen Basic settings Disc Setup menuDisc Setup menu Chapter Input Disc NameHDD Initialize Disc Setup menu Initialize settingsFinalize settings FinalizeSetting the picture quality for TV and external inputs Video/Audio Adjust menuVideo/Audio Adjust menu Chapter Choosing a presetSelect the picture quality setting you want to adjust Video/Audio Adjust menuSetting the picture quality for disc playback Audio DRC Using the Initial Setup menu Initial Setup menuInitial Setup menu Chapter Clock SettingInput Line System Initial Setup menuRemote Control Set On Screen DisplayAuto Channel Setting Tuner settingsSetup Navigator Manual CH SettingComponent Video Out Video In / Out settingsInput Colour System Input Line System Built-in tuner External inputNtsc on PAL TV Audio In settingsInput Line System Ntsc on PAL Output when Stopped External AudioAudio Out settings Language settings Subtitle Display Auto LanguageDVD Menu Language Selecting ‘Other’ languagesOptimized Rec Recording settingsManual Recording Navi MarkPlayback settings Seamless Playback Parental Lock Set PasswordParental Lock Change Password Parental LockParental Lock Change Level Parental Lock Country CodeAngle Indicator Using the TV remote control buttons Resetting the recorderSetting up the remote to control your Additional informationAdditional information Screen sizes and disc formats When viewing on a standard TV or monitorWhen viewing on a widescreen TV or monitor General Additional information TroubleshootingProblem Remedy Additional information Can’t use One Touch Copy HDD to DVD Frequently asked questionsProblem Can’t use One Touch Copy DVD to HDDAbout DV DV-related messagesVideo mode Setting upMaking a timer recording Additional information Manual recording modesLanguage Language code letter, Language code Additional information Language code listCountry code list Country, Country code, Country code letterMessage Storing discs Handling discsDamaged discs Message Explanation/ActionCondensation Additional information Cleaning the pickup lensHints on installation Moving the recorderAdditional information Glossary PCM Pulse Code Modulation Mpeg videoOptical digital output PBC PlayBack Control Video CD onlySupplied accessories Additional information SpecificationsTimer TunerIndex 123 Pioneer Electronics USA INC
Related manuals
Manual 8 pages 31.78 Kb Manual 4 pages 38.37 Kb