Getting started | Pioneer PRV-9200 instruction

04Getting started

After selecting Antenna or Cable the recorder starts automatic tuning. This takes a couple of minutes to complete.

Tuning

7/68

Cancel

Some TV channels broadcast time signals together with the program. This recorder can use these signals to set the clock automatically.

Set ‘Clock Set CH‘ to the channel preset number that broadcasts a time signal, then move the cursor down to ‘Start’ and press ENTER.

Playback

The recorder takes a short while to set the time. After you see that the time has been set, select Next to proceed.

Playback	Next

If the time could not be set automatically, press RETURN to go back to the previous screen and select Manual.

•Manual clock setting

If no stations in your area are broadcasting time signals, you can set the clock manually.

Use the	(cursor left/right) buttons to set
your time zone.
Initial Setup
Basic	Clock	Manual Clock Setting		1/2
Tuner	Input			USA
Video In/Out	On	Time Zone		USA
Video In/Out	On	Time Zone		Alaska
Audio In	Front			Alaska
Audio In	Front
Audio Out	Remote		Off
Language	Setup	D.S.T.	Off

Recording

Playback

Press (cursor down) then use the (cursor left/right) buttons to set D.S.T. to On or Off, then press ENTER.

Select On if you are currently using daylight saving time.

• Use the	(cursor up/down) buttons to change
the value in the highlighted field.
• Use the	(cursor left/right) buttons to move

from one field to another.

• Press ENTER to finish setting the time.

Use the	(cursor up/down) buttons to select, then
press ENTER.