Pioneer PRV-9200 operating instructions Selecting the hard disk or DVD for playback and recording

Getting started 04

Use the (cursor up/down) buttons to select

Compatible, Not Compatible, or Don’t Know, then press ENTER.

•Note that progressive scan video is only output through the component video outputs (see page 16).

9Is this recorder connected to an AV amp/receiver for digital audio?

Initial Setup
Basic	Clock AV Amp Digital Connect
Tuner	Input
Video In/Out	On	Connected
Audio In	Front
Audio Out	Remote	Not Connected
Language	Setup
Recording
Playback

Use the (cursor up/down) buttons to select

Connected, or Not Connected, then press ENTER.

•If you select Not Connected, that completes the setup. Press ENTER to exit the Setup Navigator, or select Go Back if you want to start again.

10Select the digital audio formats your AV amp/ receiver is compatible with.

Initial Setup
Basic	Clock AV Amp Compatibility
Tuner	Input
Video In/Out	On	Dolby Digital
Audio In	Front
Audio Out	Remote	Dolby Digital,DTS
Language	Setup	PCM only
Recording
Playback

Use the (cursor up/down) buttons to select Dolby

Digital, Dolby Digital, DTS or PCM only, then press

ENTER.

•Check the operating instructions that came with your AV amp/receiver if you’re not sure what it’s compatible with.

11Is your AV amp/receiver compatible with 96 kHz digital audio?

Initial Setup
Basic	Clock 96kHz PCM Compatible
Tuner	Input
Video In/Out	On	Compatible
Audio In	Front
		Not Compatible
Audio Out	Remote
Language	Setup	Don't Know
Recording
Playback

12That’s it! Press ENTER to finish setting up, or select ‘Go Back’ if you want to start again.

Initial Setup
Basic	Clock
Tuner	Input	Setup is complete!
Video In/Out	On
		Enjoy using your DVD recorder!
Audio In	Front
		Finish Setup
Audio Out	Remote
Language	Setup	Go Back
Recording
Playback

Other settings you can make

After setting up using the Setup Navigator, you should be ready to start enjoying your DVD recorder. It’s possible, however, that you may want to make a couple of additional settings, depending on how the recorder is set up for TV broadcasts.

•Manual channel setting – This setting lets you skip channels where there is no station, as well as manually tune to stations. See Manual CH Setting on page 97.

•VCR Plus+ channel setting – This setting lets you assign guide channels to ensure that the VCR Plus+ programming system works correctly. See VCR Plus+ CH Setting on page 97.

That completes basic setup using the Setup Navigator.

•Setting up the remote to control your TV – You can set up the supplied remote control to control many brands of TV. See Setting up the remote to control your TV on page 108.

Selecting the hard disk or DVD for playback and recording

The HDD and DVD buttons (remote control and front panel) are used to select the hard disk (HDD) or DVD for playback and recording. The indicator in the front panel display shows which is currently selected.

HDD DVD

Use the (cursor up/down) buttons to select

Compatible, Not Compatible, or Don’t Know, then press ENTER.

•Check the operating instructions that came with your AV amp/receiver if you’re not sure.

27

En