Roberts Radio R9968 manual Batteries

Page 7

Batteries

1.Batteries should be replaced when the Battery Level icon shows low.

2.Press the On/Off Sleep button to switch the radio off before replacing the batteries.

3.Open the battery cover located on the underside of your receiver by pressing down and lifting the battery cover.

4.Insert 2 x AA batteries into the compartment. Make sure that the (+) and (-) ends of the batteries are positioned as shown on the rear of the receiver.

Note: 2 beep sounds will be heard to signify correct battery insertion.

5.Close the battery cover.

6.Press the On/Off Sleep button to switch the receiver on after the batteries have been replaced.

7.If the receiver is not to be used for an extended period of time it is recommended that the batteries are removed from the receiver.

8.When the power is too low for the receiver to operate the Battery

Level icon will flash and the unit will shut down automatically.

2

6

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

7

Image 7
Contents R9968 Contents Overview Controls Front Controls Right side Left side Bottom Controls TopControls Back Batteries Disabling the buttons Switching on and setting the time zoneSetting summer time Setting the local timeShort wave radio reception Switching between local time and GMTListening to the radio Setting the alarm time Setting the alarm to buzzer 911 Setting the alarm to radioSnooze control Checking the alarm timeBacklight Sleep timerHeadphones ResetStereo/Mono reception headphone use only Power Requirements Circuit Features SpecificationsGuarantee Roberts Radio Technical Services