Nady Systems PSS-150 Rear Panel Controls & Connections, Specifications, MAX Gain, Distortion

Page 7

Rear Panel Controls & Connections

(18) (16) (17)(19)

(16) FUSe HOLDeR & POWeR CORD CONNeCTOR

This fuse holder contains an AC primary fuse. When this fuse blows, replace it with the same type fuse, size and power rating (see SPECIFICATIONS). If it continuously blows, stop replacing the fuse and refer servicing to qualified personnel. The cord connector is used to connect the AC power source to your power amplifier.

(CAUTION: After checking the AC supply voltage, be sure that the correct fuse is in the fuse holder.)

(Note: use at the improper voltage can damage your unit and void the warranty.)

(18) POWeR SWITCH

Use this switch to power unit ON or OFF. Before turning on this unit, verify connection to the proper voltage AC source, check all connections and turn down the level controls of equipment connected to the outputs.

 

(19) SPeAKeR 1/4” OUTPUT JACKS

(17) AC VOLTAGe SeLeCT SWITCH

Connect to the left and right PSS-150 speakers.

Before plugging in the power cord, check to see that the unit is set

 

for the proper voltage for your area: ~115V (60Hz) or ~230V (50Hz).

 

Specifications

OUTPUT POWeR

75 watts �MS per channel into 4 Ohms load

OVeRLOAD PROTeCTION

AMA™ (Automatic Maximum Amplitude) servo system limits the power amplifier input to

 

prevent clipping distortion that can damage speakers

FReQUeNCY ReSPONSe

40 Hz to 20 KHz measured at 1 watt

TONe CONTROLS

Bass: 100 Hz ±+/-10 dB; Treble: 10 KHz +/-10 dB

GRAPHIC eQUALIZeR

5 bands; 100 Hz, 350 Hz, 1 KHz, 3 KHz, and 8 KHz with FLI™ (Feedback Locating Indicators)

DSP eFFeCTS

Hall/�oom/Plate �everbs, Chorus, Flanger, Delay, Vocal Cancel, Chorus/�oom, �otary Speaker

INPUT IMPeDANCe

Mic input: 2 K Ohms, Line input: 12 K Ohms

MAX GAIN

86 dB mic input to speaker output

DISTORTION

Less than 0.8% THD at rated output

SIGNAL / NOISe RATIO

85 dB mic input typical

ReVeRB/DeLAY

DSP digital reverb and digital delay

SPeAKeRS

Woofer 10” (254mm) and piezoelectric horn tweeter

AC POWeR

120 VAC (60 Hz) or 230 VAC (50/60 Hz)

DIMeNSIONS

27.6” x 15.75” x 23.4” (70.2 cm x 40 cm x 59.4 cm)

WeIGHT (assembled)

59.4 lbs (27Kg)

MICROPHONe

Unidirectional (cardioid) dynamic

7

Image 7
Contents PSS-150 Features ContentsPage Speakers and Stands InstallationCONTeNTS Mixer SectionFront Panel Controls & Connections AUX RCA Outputs DSP Effects DisplayDistortion SpecificationsRear Panel Controls & Connections MAX GainService For Your Nady Audio Product