iHome IP49 manual Using the Aux Line-In Jack with Other Audio Devices, Using the Sleep Timer

Page 10

Listening to FM Radio

Setting FM Radio Frequency/Range to Use iP49 in Other Countries

Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US, you may skip this section.

1.Make sure the iP49 is OFF (not playing in any mode). Press and hold the Radio/AUX Button for about 5 seconds until

“USA” flashes in the lower part of the display. Press the or Button to select your region (EU=Europe, JPN= Japan, AUS=Australia, CHN= China).

2.Press the Radio/AUX Button again (or no button within 5 seconds) to exit the radio frequency setting mode. Two beeps will confirm the setting is complete.

Using the Aux Line-In Jack with Other Audio Devices

The iP49 has an FM antenna/aux line-in jack that lets you play other audio devices through it. Unplug FM antenna to use aux line-in jack.

1.Plug one end of a standard 3.5mm audio patch cord (not included) into the headphone or line-out jack on your audio device and the other end of the patch cord into the iP49 aux line-in Jack, located on the rear of the unit.

2.Press the Radio/AUX Button until “AUX-IN” appears in the display, indicating aux mode is active.

3.Turn on and play your device (device must be controlled independently of the iP49).

4.Press the Volume or Button to adjust the system volume. Adjust the output volume on your device if needed.

5.To turn off the unit, press the Button. Please remember to turn off your device, too.

Using the Sleep Timer

The iP49 has an adjustable sleep timer that lets you sleep to your iPhone, iPod or FM radio before shutting off after the specified time.

1.Press the sleep button as needed to cycle through the sleep time settings: 90, 60, 30, 15 minutes or OFF (cancels sleep mode). Press the sleep button during sleep operation to review the sleep time remaining.

2. Press the Volume

or

Button to adjust the sleep volume. This is separate from the unit’s standard volume

setting.

 

 

3. To turn off the unit, press the Button.

Using the Remote auto/on Switch

The iP49 has a remote auto/on switch located on the back of the unit. Slide the switch to the AUTO position to save battery power when traveling or operating on the internal battery. AUTO disables remote operation when operating on the internal battery. Slide switch to ON position for normal remote operation.

8

Image 10
Contents Portable FM Stereo Alarm Clock Radio System for iPhone IPod Maintenance Table of ContentsFCC Information Open unit Connect to AC power Dock iPhone/iPod TimeControls and Indicators IP49 DisplayGetting Started Connect AC AdaptorCharging the Internal Battery End-Of-Life Battery Disposal InstructionsSetting the Time and Calendar using iPhone/iPod Time Sync Setting Up the iP49Setting Time and Calendar Manually Resetting the Alarm to Come on the Next Day Using the AlarmSetting the Alarm Sure AlarmListening to iPod/iPhone Listening to FM RadioUsing the Sleep Timer Using the Aux Line-In Jack with Other Audio DevicesUsing the Remote auto/on Switch Consumer Guide to Product Safety Troubleshooting Symptom Possible Problem SolutionLimited 1 Year Warranty Information