Sharp DV-L70S, DV-L70BL operation manual When recording from

Troubleshooting

		Problem		Recommended Action	Page
		The battery	•	Make sure the main power switch is in the	34, 35
		pack does not		“OFF” position. The battery pack does not
		charge.		charge when it is connected to the DVD player
				while DVD player power is turned on.
			•	A warm battery takes longer than normal to	–
				charge. Wait until the battery cools to normal
				temperature before trying to charge it.
		Power does	•	Replace the battery pack with a charged one or	33-36
		not turn on.		switch to AC adapter power.
		The battery	•	Charging of a battery pack may become	–
		charge lamp		disabled (and the charge lamp may fail to light)
	Operation	does not light		whenever heat from the DVD player causes the
		(the battery		internal temperature of an attached battery pack
		pack does not		to rise above certain level. When this happens,
		charge).		remove the battery pack from the DVD player.
				Charging will start automatically when battery
	Pack			pack internal temperature drops to a safe level.
			•	Make sure the temperature of the battery pack	86
	Battery			is within the allowable temperature range of
				10° C to 30° C for charging.
			•	Check to make sure that the AC adapter DC	33
				cable is connected correctly.
		The battery	•	Try disconnecting the AC adapter DC cable from	–
		charge lamp is		the battery pack and then reconnecting it. If the
		flashing.		battery pack is attached to the DVD player, first
				disconnect the battery pack DC cable from the
				DVD player before performing the above step.
			•	Try charging another battery pack. The same	–
				symptom occurring with another battery pack
				may indicate a problem with the AC adapter. If
				the other battery pack charges normally, it can
				indicate a problem with the first battery pack or
				that the first battery pack has reached the end
				of its normal service life.
	Cannot record to		•	Make sure the connected audio equipment is	72
	an MD.			turned on.
			• Check if linear PCM is selected as the audio mode.
	When recording from		•	When the space between tracks of some disks is	–
	a CD to an MD over			very short, two tracks can be recorded as a single
	an optical digital			track, which causes a mismatch of track numbers.
	connection, the CD		• CD and MD track numbers may not match when
	track numbers and
				recording from a CD using programmed play or
	MD track numbers
				direct skip.
	do not match.
GB 90