Sharp DK-KP85PH Wall mount preparation, Driving screws, Installing the unit, Falling prevention

Wall mount preparation

To mount the unit on the wall

Caution:

●● Be very careful to prevent the unit [2.45 kg (5.4 lbs.)] from falling when mounting on the wall.

●● Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The unit may fall.) If unsure, consult a qualified service technician.

●● Mounting screws are not supplied. Use appropriate ones.

●● Check all wall mount screws for looseness.

●● Select a good location. If not, accidents may occur or the unit may get damaged.

●● SHARP is not responsible for accidents resulting from improper installation.

■■ Driving screws

SHARP designed the unit so you may hang it on the wall. Use proper screws (not supplied). See below for size and type.

	3.2 mm (1/8”)
5 mm
(3/16”)	9 mm (3/8”)

Min. 22 mm (7/8”)

■■ Installing the unit

4Fasten the screws to the wall as shown below. (Total screw is 2 pieces).

Wall surface	Wall surface
	4.3 ~ 4.8 mm
	Gap from the wall surface

5Hang the unit onto the screws.

Wall surface

■■ Falling prevention

1Fix the pattern paper position as below.

188509mmm

Wall surface 44 mm

to the wall in horizontal

44 mm

29 mm

Pattern paper (supplied)

Safety wires (not supplied) are useful to prevent the unit from falling off the wall.

Screw eye (not supplied)

2Make a hole on the wall following the screw point marks on the pattern paper by using a drill.

32 mm (1-1/4”)

8-9 mm (3/8”)

Wall surface

3Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface.

32 mm (1-1/4”)

8-9 mm (3/8”)

Wall surface

Wall

Safety wires (not supplied)

Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to a hook (screw eye).

Ø wire > 1.5 mm

The diameter of wire/cable must be less than 1.5 mm.

E-4