Sangean Electronics DT-300/DT-300V manual Memory Scan Play

Page 14

On/off Button 5

.Select desired band by pressing Band Select or Button 8 .

Press Memory Button

11 . Memo will flash in display. Press Select Button 12

for move than 2 seconds until auto/memo appears and flashes in display.

press memory Button

11 again. The receiver will automatically begin to scan

and set memory preset positions. It will dliminate any memory presets already

with in the band.

 

 

 

F.Memory Scan

Play

 

Turn on receiver by pressing On/Off Buttons 5

.Select desired band by pressing

Band Selector Button

8 .Select a preset station with in band selected. Make sure

the Select Cursor

L

is in the Memory Position

H by pressing Select Button 12 .

Press Tuning Control Button 13 or 14 for more than 1/2 second and release. Display will show auto and flash The receiver will scan each preset,play for about 2 seconds and go on to the next preset. Press Tuning Control Button 13 or 14 will stop scaning and select station desired.

14

Image 14
Contents Page Page Location Of Controls Location of ControlsPage Display Icons Battery Installation Setting Time Long Term Alarm SetShort Term Alarm Set Speaker On/Off Switch Antenna/Earphone UseVolume Control Tuning the Radio Band Frequency AntennaScan Tuning Manual TuningSetting Presets Manually Selecting Memory Presets Automatic Memory Preset System APSMemory Scan Play Deleting Memory Positions Weather Band WX Reception-DT-300VW onlyLock Switch Mono/Stereo ButtonWeight 3.33 OZ SpecificationOutput Power Earphone jack