Sangean Electronics DT-300/DT-300V manual Setting Time, Long Term Alarm Set

Page 7

Setting Time

When batteries are installed for the first time the LCD display time digit will flash indicating that the time needs to be set. The clock can be set with

the power off but the lockswitch 3 must be off. To set time press Time Set Button 8 for more then 2 seconds until hour digit flashes. While hour digit is flashing use Time Adjust Buttons 13 and 14 to select the correct hour. Pressing Time Set Button 8 again will cause the minite digit to flash. Use same procedure as hour set to set minite set. Press Time Set Button 8 to finalize time setting.

Long Term Alarm Set

Press Standby Button 11 for more than 2 seconds until hour digit flashes. Press Time Adjust Button 13 and 14 to set the required hour and then Press the Standby Button 11 again to cause the minute button to flash. Set minute desired same way as hour was set. Press Standby Button again to finalize setting.

7

Image 7
Contents Page Page Location of Controls Location Of ControlsPage Display Icons Battery Installation Long Term Alarm Set Setting TimeShort Term Alarm Set Antenna/Earphone Use Speaker On/Off SwitchTuning the Radio Band Frequency Antenna Volume ControlManual Tuning Scan TuningSetting Presets Manually Automatic Memory Preset System APS Selecting Memory PresetsMemory Scan Play Weather Band WX Reception-DT-300VW only Deleting Memory PositionsMono/Stereo Button Lock SwitchEarphone jack SpecificationOutput Power Weight 3.33 OZ