Sangean Electronics DT-220A manual Setting the alarm time, Wake to alarm

Setting the alarm time

1.Ensure that the radio is switched off.

2.Press and hold down the Alarm button for more than 2 seconds until the hours digit and alarm symbol begin to flash in the display.

3.Whilst the hours digit is flashing, adjust the hours using the Tuning Up/Down buttons.

4.Press the Alarm button, the minute digit begins to flash in the display.

5.Whilst the minute digit is flashing, adjust the minutes using the Tuning Up/Down button.

6.Press the Alarm button to complete alarm

time setting. The Alarm symbol will appear on the display indicating the alarm is set.

Wake to alarm

1.At the pre-selected time, the alarm will beep. The alarm may be turned off for 24 hours by pressing any button. The alarm will switch off automatically after 3 minutes.

2.To permanently cancel the alarm, press the

alarm button, the alarm symbol will be removed from the display.

GB

5