Motorola V.3600 manual Disable automatic rate adaption, Maximum block size, Characters

Command Index and Defaults

Table E-1. Synchronous Command Reference (Continued)

Command	Page	S-Reg	Description
%R	5-30	S53	Disable automatic rate adaption
%R1		S53	Enable automatic rate adaption low BER
%R2		S53	Enable automatic rate adaption medium BER
%R3		S53	Enable automatic rate adaption using high
			BER
%T	7-7	--	Transmit test pattern †
%T=	5-43	--	Followed by a remote configuration security
			code, establishes remote configuration †
%V	5-31	--	Display product revision level
\A	6-10	S63	Maximum block size of 64 characters
\A1		S63	Maximum block size of 128
			characters
\A2		S63	Maximum block size of 192
			characters
\A3		S63	Maximum block size of 256
			characters
\B	6-11	S79	Transmit a break signal
\Bn		S79	Sets break length in 20 ms increments,
			n=1-255, default is 35 (700 ms)
\C	6-11	S60	Disable auto-reliable buffer
\C1		S60	Buffer data for 4 seconds or 200
			characters
\G	6-8	S54	Disable modem port flow control
\G1		S54	Enable modem port XON/XOFF flow control
\J	6-4	S72	Disable slaved DTE/DCE speed
			(constant speed DTE on)
\J1		S72	Enable slaved DTE/DCE speed
			(constant speed DTE off)
\J2		--	Enable 230.4 kbps DTE speed
\J3		--	Disable 230.4 kbps DTE speed

Note

The 230.4 kbps DTE speed is available, but the DTE will not autobaud to 230.4 kbps. With the modem set for 115.2 kbps, enter AT\J2 to enable the speed, and reset the DTE for 230.4 kbps. When the modem is set for 230.4 kbps, enter AT\J3 to disable it if needed. Reset the DTE for 115.2 kbps.

†cannot be executed from remote configuration mode

V.3600 E-7