Motorola V.3600 manual Break Control \Kn, Break option

Protocols

Break Control — \Kn

Use \Kn (n = 0-5) to indicate the action taken by the modem when a break is encountered.

Command	Operation
\K	Break option 0
\K1	Break option 1
\K2	Break option 2
\K3	Break option 3
\K4	Break option 4
\K5	Break option 5

Conditions under which breaks may occur are explained below with descriptions of the modem’s response under the different \K command break options.

A break is sent to the serial port while the modem is in connect state during a reliable or normal connection (no protocol, data buffered).

Command	Operation
\K, \K2,	Enter command mode but do not send break to the remote
\K4	modem
\K1	Empty the data buffers and send break to the remote modem
\K3	Immediately send break to the remote modem
\K5	Send break to the remote modem in sequence with any data
	received from the serial port

A break is sent to the serial port while the modem is in connect state during a direct connection (no protocol, data not buffered).

Command	Operation
\K, \K2, \K4	Immediately send break to the remote modem and enter
	command mode when break is through
\K1, \K3, \K5	Immediately send break to the remote modem

V.3600 6-9