Motorola V.3600 manual Security Commands, High Security, Disable security, Reinitialize security

Command Index and Defaults

Security Commands

Command	Page	Description
Low Security
$S=x	8-4	Sets an empty password location to x
$C=x,y		Changes either password where x represents the old
		password and y is the new one
$C=x,-		Deletes password x from memory
$DR		Reset security
$D=x		Disables security where x is either password
$D? or		Displays the current status of security
$E?
$E=x		Enables security where x is either password
High Security
$Cn=m	8-9	Set user callback number. n = user number and m =
		the callback number
$D	8-8	Disable security
$E? or	8-10	Display current security status
$D?
$EH=pw	8-7	Enable security (pw = superuser password) †
$F=	8-10	Reinitialize security
pw$pw
$IBn	8-11	Display user information for a block of up to ten valid
		users (n = first user number)
$In		Display user information (n = user number)
$Ln=m	8-8	Set security level for the user specified by n
		(m = security level)
$M		Display illegal attempts information
$M*		Reset illegal attempts registers/restore suspended
		users to normal status
$Mn		Reset illegal attempts registers and restore suspended
		user n to normal status
$Pn=	8-8	Set user password; n = user number and new
pw$pw		password (n = 0 for superuser pw = password)
$Rn	8-10	Remove a user (n = user number)
$S?	8-11	Display current user status (superuser / user)

† cannot be executed from remote configuration mode

E-14 V.3600