Motorola V.3600 manual Disabling High Security $D, Setting Passwords $Pn=pw$pw

Security

Disabling High Security — $D

Enter the $D command to disable security. The modem will operate as a nonsecure unit except that it will respond to enable and check security status commands.

Setting Passwords — $Pn=pw$pw

Select a password between 4 and 34 printable ASCII characters.

To store the password enter

AT$Pn=pw$pw

where n is the user number (0-50) and pw is the new password which is entered twice to ensure that is has been entered correctly.

The $ character is used as the marker between the dual password entries and cannot be used as part of the password.

Passwords cannot be recalled from nonvolatile memory.

Note

The superuser password is critical because the security feature cannot be configured without it.

After logon as USER 1 and gaining superuser privileges, enter the $Pn command to modify passwords.

For the superuser enter

AT$P0=pw$pw

For user 1 enter:

AT$P1=pw$pw

Record the passwords in your personal records.

IMPORTANT: Systems administrator functions cannot be accessed without it. If you forget the superuser password, contact Technical Support. Refer to the “Calling Technical Support” section on page 12-2.

Set Security Levels — $Ln=m

The System Administrator (superuser) assigns each user with a security level by entering the $Ln=m command where n is the user number and m is the security level.

8-8 V.3600