Motorola V.3600 manual Disable protocol result codes, No XON/XOFF characters to remote DCE

Command Index and Defaults

Table E-1. Synchronous Command Reference (Continued)

Command	Page	S-Reg	Description
\V	10-18	S60	Disable protocol result codes
\V1		S60	Enable protocol result codes
\V2	--	--	Connect DCE rate
\V3	--	--	Connect DCE rate/protocol
\V4	--	--	Connect DCE rx rate/DCE tx rate/
			modulation mode/protocol
\X	6-8	S54	No XON/XOFF characters to remote DCE
\X1		S54	Pass XON/XOFF characters to remote DCE
*AS	5-27	--	Disable V.34 asymmetric bit rate
*AS1		--	Enable V.34 asymmetric bit rate
*AUn	5-16	--	Dial number stored at location n upon
			transition of DTR in command mode
			(n = 1-9)
*CNx,n	5-40	--	Store phone number n in location x (x = 1-9)
*DA	5-32	--	Switches modem to talk mode †
*DA1		--	Switches modem to data mode †
*DB	5-36	S32	Manual dial backup operation
*DB1		S32	Automatic dial backup operation
*DG	7-7	S34	Disables bilateral digital loop
*DG1		S34	Enables bilateral digital loop
*FB	5-22	S29	Ignore pin 23
*FB1		S29	Pin 23 transition causes DTE speed fallback
*FT	5-32	S29	Disable fast train
*FT1		S29	Enable fast train
*IC		--	Disregard incoming call
*LA	7-8	S34	Ignore pin 18
*LA1		S34	DTE commanded LAL enabled
*LB	5-36	--	Return to leased line from dial backup†
*LC	5-32	S32	Line current disconnect disabled
*LC1		S32	Short (8 ms) line current disconnect
*LC2		S32	Long (90 ms) line current disconnect
*LD	5-36	--	Manual dial backup

† cannot be executed from remote configuration mode

V.3600 E-9