Memorex MMG-CR3810 operating instructions If Your Cabinet has AN Overhang, Tips

MMG-CR3810.OM.QXD 7/15/02 7:09 AM Page 8

	MOUNTING (CONTINUED)
3b.	IF YOUR CABINET HAS AN OVERHANG:
	Measure the thickness of
	the overhang (see Figure		MeasureThickness
	3). Fold the front of the
	template down along the
	printed guideline that is
	closest to the thickness of
	your cabinet. Tape the
	folded portion to the		ofCabinetOverhang
	backside of the overhang,	Figure 3
	then tape the template
	underneath the cabinet (see
	Figure 4).
NOTE: If the cabinet has glue
blocks or other obstructions, cut
out corresponding areas on the
template to clear them. Do not
		Template		Foldat
cut through the screw holes
indicated on the template.
				DottedLine
4.	Drill 1/4” diameter holes	Figure 4
	underneath the cabinet

using the four points marked on the template.

TIPS:

•On a wooden cabinet, you may want to mark and start the drill holes with a nail or an awl.

•Make sure to hold the drill very firmly against the cabinet to reduce “walking” of the drill bit from the markers.

•Use masking tape above the hole locations on the inside of the cabinet to reduce splintering.

•If installing the unit under a wood cabinet, you may wish to countersink the drilled holes from the inside. This will eliminate the use of washers and allow the screwheads to be flush with the floor of the cabinet. If you cannot countersink the holes, use the supplied washers.

•Always wear goggles.

•DO NOT mount above a sink or stove.

5.Remove the template and clean the drill shavings from inside and underneath the cabinet.

6.If your cabinet does not have an overhang, skip this step.

If your cabinet has an overhang, select the spacer or combination of spacers that is equal to or longer than the cabinet overhang (see Figure 5 on the next page).

8