Mounting the Unit

Template

Figure 2

MMG-CR3810.OM.QXD 7/15/02 7:09 AM Page 7

MountingTemplateMOUNTINGScrews2-3/4"(4andofeach1-5/8"size)

This under the cabinet CD clock radio has be n designed to be installed underneath a woodenSpacerscabinet(4ofeachby usiznge)the MountingWshersTemplate, four (4) Screws, four (4) Washers and1" f r (4)1/2"Spacers (see1/4"Figure 1).

Figure 1

Locate a desired space for the CD clock radio (it is recommended to mount the unit at the front edge of the cabinet) and follow the instructions below and on the next few pages to mount.

1.Empty the contents of the cabinet where the unit will be mounted. Clean under the cabinet before mounting.

NOTE: For optimal mounting, the screws must go into the unit to a depth of at least 3/8”. If the overall length from the bottom of the cabinet shelf to the bottom of the overhang is more than 1-3/4”, a wood shim must be used. A shim can be made from a small sheet of plywood, using the template to locate the central lines for drilling 1/4” mounting holes. The shim can be located between the cabinet shelf bottom and spacers. Make sure the shim is at least as thick as the excess over 1-3/4”. If a shim is necessary, longer screws are required. Longer screws (type #10-32) are available at most hardware stores.

2.Cut out the template on the line indicated on the template. The template size and screw hole positions are identical to the top of the unit.

3a. IF YOUR CABINET DOES NOT HAVE AN OVERHANG: Position the template

in the desired location underneath the cabinet, flush with the front edge. Then, tape the template in place (see Figure 2), and continue to step 4.