JBL EVO1.324 manual Installation, Overview, Suspension, Eyebolt Kit

Page 20

I N S T A L L A T I O N

Overview

EVOi.324 has been designed to be permanently installed. An eyebolt kit has been provided to facilitate suspension from above: a ceiling, a beam or overhang. EVOi.324 weighs 65 pounds (29.5 Kg) and attaching this loudspeaker to a surface is a task that should not be taken lightly. Always consult a qualified person.

Suspension

WARNING !! Suspending this system should be done by qualified persons following safe rigging standards. For more information, please refer to the JBL Technical Note Volume 1, Number 14 – Basic Principles for Suspending Loudspeaker Systems.

For Example: Maximum Load Rating divided by EVOi.324 Net Weight = The number of speakers in a vertical array.

142.8 lb (67.8 Kg) / 65 lb (29.5 Kg) = 2.1

Therefore only two EVOi.324s may be used in a vertical array if they are suspended from the points located on the top of the enclosure in either recommendations 1 and 2 stated above.

Eyebolt Kit

Parts Included:

3Shoulder Eyebolts

3Washers

1Suspension Advisory and Tech Note

Before suspending an EVOi.324, be sure to inspect all components for cracks, deformations, corrosion, and/or missing or damaged parts that could reduce the strength and safety of the installation.

Perform all calculations to ensure that all components are used within their rated work load before suspending an EVOi.324. Remember the weakest component determines the size and safety of the entire installation.

There are 3 suspension points on the top and bottom of EVOi.324, two toward the front of the enclosure and one to the rear. Pull tests at a certified test facility have docu- mented non-catastrophic failure at 450 – 550 pounds for each individual front suspension point and 1000 pounds for the rear suspension point.

Installing Eyebolts:

1.Remove suspension placeholder screws.

2.Coat each eyebolt with thread-locking material (e.g., LocTite #2 or equivalent).

3.Using the included washers as stand-offs, thread the eyebolts into the open holes and tighten.

Eyebolt

Placeholder Bolt

Figure 25 - Remove Placeholder Bolts

It is recommended that EVOi.324 be either suspended:

1.Equally from both of the front suspension points together, or

2.From the rear suspension point, with the addition of a safety cable to another suspension point.

For both recommendations, assuming a 7:1 safety factor, the load on the suspension points should NEVER be greater than 142.8 pounds (67.8 Kg).

Washer

Figure 26 - Install Washers

and Eyebolts

18

EVOi.324

Image 20
Contents EVOi.324 EVOi.324 N T E N T SImportant Safety Information Read this Carefully T R O D U C T I O N WelcomeS I G N O V E R V I E W A T U R E S Switch-Mode Power Supply Compact DesignHandle/Grip XLR Audio / Communication InputPower Requirements Power Cycle Boot-up TimesEVOi.324 Rear Output on Generic Mixer EVOi.net RearP L I C a T I O N S Schools and Sports Facilities Performance VenuesPlaces of Worship Rectangular-Shaped Room Fan-Shaped RoomEVO Sound System Design Basics EVOi.324 Coverage AnglesHorizontal Coverage Angles Vertical Coverage Angles Horizontal Coverage = Vertical Coverage =Throw Ratio Area CoverageUsing More Than One Speaker Aiming EVOMaximum Performance Guideline Stereo and ArraysWhen to use Delay Speakers Basic Delay Speaker PlacementLonger Rectangular Room Main Mono + 1 Delay Mono Small Rectangular Room Main MonoLonger/Wider Rectangular Room 2 Main Stereo + 2 Delay Stereo Small/Wider Rectangular Room Main StereoUse EVOi.net To set actual delay and level Delay Small Fan Shaped Room Main Mono Medium Fan Shaped Room 2 Main Mono ArrayLarge Fan Shaped Room Main Mono Array + 2 Delay Mono I N T I N G Instructions for PaintingInstallation OverviewSuspension Eyebolt KitPlaceholder Bolt Installing FeetFoot Kit Troubleshooting AC PowerEVOi.324 doesn’t power up Power LED is FlashingP E N D I AC Power RequirementsEVOi.324 Sensitivity Chart O i 2 4 Specification s C H N I C a L D a T aJBL Limited Warranty R R a N T YT E S D E Harman International Company