Speaker Connection

Getting connected cont

The GIG MAN PLUS has a set of speaker connectors for connection to external speakers. Remember that only speakers with an impedance rating of 8 ohms should be connected.

To connect speakers, ﬁrst unlock the plastic fasteners on each speaker connector by pushing downward on them. Then strip approximately a 1 /2” (1.27cm) of insulation from the speaker wire ends and twist the strands so that they can easily slide through the holes. Once a wire is inserted, lock them in place with the fasteners by pushing upward on them. It is easy to over-insert a wire into a speaker connector so that the insulation is inserted as well. To ensure this doesn’t happen, only insert the wires to the point where you can still see the edge of the insulation.

Speakers

*Set to EXT for External Speaker Output

INT EXT

Speacker Selector

AM/FM Antenna Connection

Connecting the FM Antenna to the GIG MAN PLUS

SPEAKER 8

The FM antenna looks like a thin wire with a gray plastic plug at one end. To connect the FM antenna to the GIG MAN PLUS, insert the gray plug into the FM antenna receptacle.

AM/FM

INPUT	INPUT	www.vocopro.com
FM/ANT	AM/ANT
			www.vocopro.com
		VCD+CDG	COMBO Model: GIGMAN PlUS

VOCOPRO

www.vocopro.com

Rated:AC~115/230V,50/60HZ, 70W

Class1 Laser Product

This product complies with DHHS Rules21CFR Chapter1,

Subchapter J

Made in China

Manufactured Date:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two Conditions:(1)This device may not cause harmful Interference,and (2)This device must accept any interference that may cause undesired operation

AV1 INPUT

		L	R	VIDEO
	ON
	OFF
Power		L	R	VIDEO
Commutator
			AV2 INPUT
BALANCED AUDIO OUTPUT		BALANCED MIC OUTPUT
L	R	MIC 1		MIC 2

T2A/125V

INT EXT

Speacker Selector

SPEAKER 8 Ω

VIDEO	AUDIO	C UL US
OUT	OUT
	L
AC IN		LISTED
AC115V	R	(AUDIO PRODUCT)
AC115V		XXXX
50/60GHZ

Connecting the AM Antenna to the GIG MAN PLUS

The AM antenna has a braided wire connected to a large oval shaped plastic antenna. The opposite end has two exposed cop- per-colored wires.

To connect this antenna, press down the tabs on the AM antenna receptacle on the back of the GIG MAN PLUS. Now insert the copper-colored wires into each side of the receptacle and then release the tabs to secure the wires in place.

Getting connected cont