Harbor Freight Tools 93762 To Attach The Bandsaw To The Stand, To Attach The Stock Stop Assembly

To Attach The Bandsaw To The Stand:

STAND

(TOP VIEW)

	MOUNTING HOLE
MOUNTING HOLE	MOUNTING HOLE

MOUNTING HOLE	MOUNTING HOLE
	MOUNTING HOLE

SCREW (59)

SPRING WASHER (58)

FLAT WASHER (57)

FIGURE B

1.With additional manpower, and an adequate lifting device, carefully set the Bandsaw on top of the Stand as- sembly, making sure the upper sec- tion of the Stand fits outside the base of the Bandsaw. (See Figure B.)

2.Align the three threaded mounting holes in each end at the base of the Bandsaw with the three mount- ing holes located at each end of the Stand assembly. Then secure the Bandsaw to the Stand assembly, us- ing three Screws (59), three Spring Washers (58), and three Flat Wash- ers (57). (See Figure B.)

To Attach The Stock Stop Assembly:

1.When mounted to the Bandsaw, the adjustable Stock Stop assembly is used to make repetitive cuts of the same length.

HEX BOLT (149)

SOCKET HEAD

SCREW (156)

SHAFT (158)

STOCK

STOP (157)

END VIEW

WITH

HAND WHEEL (171)

IN FOREGROUND

FIGURE C

2.To attach the Stock Stop assembly, slide the Shaft (158) into the mount- ing hole in the Machine Bed (142), and secure the Shaft by tightening the Hex Bolt (149). (See Figure C)

3.Slide the Stock Stop (157) onto the Shaft (158), and secure by tightening the Socket Head Screw (156).

(See Figure C.)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 10