Harbor Freight Tools 93762 Basic Bandsaw Operation Horizontal Position, See Figure T

from its electrical outlet.

(See Figure S.)

15.Wait until the Saw Blade (82) comes to a complete stop. Then, remove the workpiece and scrap material from the Vertical Cutting Plate (189).

(See Figure S.)

16.Remove the Locking Pin (153) and turn the Support Plate (150) to the left. Then, lower the Body Frame

(60)to its horizontal position.

(See Figure S.)

Basic Bandsaw Operation --

Horizontal Position:

1.WARNING! Always wear ANSI- approved safety impact eye goggles when operating the Bandsaw.

2.Do not plug the Power Cord Plug into an electrical outlet until all necessary adjustments (as previ- ously discussed in this manual) have been made.

3.Raise the Body Frame (60) to its full vertical position, making sure it locks in place by turning the Support Plate

(150) to the right until it firmly locks into the Body Frame and inserting the Locking Pin (153). (See Figure S.)

4.Secure the workpiece in the Vise as- sembly (138, 141). When cutting a large workpiece, make sure its entire length is properly supported. If nec- essary, use a roller stand (not includ- ed) with a larger workpiece.

(See Figure T.)

5.If cutting several workpieces at the same length, you may wish to adjust the Stock Stop (157) to the desired position. (See Figure T.)

6.Once all necessary adjustments to the Bandsaw have been made, plug the Power Cord Plug into the near- est 120 volt, grounded, electrical outlet. (See Figure T.)

7.Turn the Power Switch (164) to its “ON” position, and slowly lower the Body Frame (60) until the Saw Blade

(82)is just above the workpiece cut line. (See Figure T.)

8.Before cutting, turn on the Bandsaw and check for excessively loose Saw Blade (82) tension or machine vi- bration. If this is found, turn off the Bandsaw and correct the problem before using. (See Figure T.)

9.Allow the Saw Blade (82) to turn up to full speed before feeding the Saw

BODY FRAME

(60)

VISE ASSY.

(138, 141)

SWITCH PUSH-

OFF TIP (41)

				SUPPORT PLATE
				(150)
POWER SWITCH	STOCK	STOP
			LOCKING PIN	FIGURE T
(164)	(157)		(153)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 19