Harbor Freight Tools 93762 operating instructions See Figure F, See Figures G

e. Place the new Saw Blade (82) be- tween each of the Guide assemblies and around the Upper Blade Wheel

(37) and Lower Blade Wheel (54).

IMPORTANT: The teeth must be pointing downward toward the Motor. (See Figure U.)

f.NOTE: The Bandsaw is equipped with a 64” diameter, .025” thick,

15/32” wide, 14 teeth per inch Saw

Blade (82). The machine will also accept Blades in 4, 6, 8, and 10 tooth sizes. The choice of Blade pitch is determined by the thickness of the material to be cut. The thinner the workpiece, the more teeth is rec- ommended. A minimum of 3 teeth should engage the workpiece at all times for proper cutting.

(See Figure U.)

CAUTION: If the teeth of the Saw Blade are so far apart that they straddle the workpiece, severe damage to the workpiece and/or Saw Blade will result.

g.Tighten the tension on the new Saw Blade (82) by turning the Blade Ten- sion Knob (34). (See Figure U.)

h.Close the Blade Back Cover (114).

(See Figure U.)

4.To replace the V-Belt:The Band- saw uses a size 0-506 V-Belt (10). To replace the V-Belt:

HEX BOLT

(70)

SPINDLE PULLEY	MOTOR PULLEY
(1)	(79)

V-BELT (10)

FIGURE V

a. Open the Pulley Cover (72).

(See Figure V.)

b. Loosen the Hex Bolt (70) to release tension on the old V-Belt.

(See Figure F.)

c. Remove the old V-Belt (10) from the two Pulleys (1, 79). (See Figure V.)

d. Place the new V-Belt (10) into the proper Pulley (1, 79) combination for the desired Blade speed.

(See Figures G and V.)

e. Adjust the position of the Motor (81) to obtain approximately 1/2” depres- sion in the V-Belt (10) when applying pressure with your thumb.

(See Figure V.)

f.Tighten the Hex Bolt (70) to secure the Motor (81) in place.

(See Figure T.)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 22