4 Using the Symbio AVHD recorder
Using the TV remote control to operate the Symbio AVHD recorder
The Symbio AVHD recorder uses commands similar to those on a standard VCR, including RECORD, PLAY, FORWARD, REVERSE (REWIND), and PAUSE. When the Symbio AVHD recorder is connected to your Toshiba integrated HD television and the remote control is in “TV” mode, the applicable remote control buttons will operate the Symbio (see illustration below).
Use remote control model
To use the remote control to operate the Symbio:
Press MODE to select “TV” mode. (See your TV owner’s manual for additional details about the remote control.)
Important information about AVHD recording and playback
•Never disconnect the power cord from the wall outlet or break the power supply to the Symbio AVHD recorder during recording or playback. When the power cord is disconnected or a power failure occurs during any operation of the recorder, some recorded content (typically content in the recording buffer) may be lost or become irretrievable or inaccessible.
•Recorded image and sound quality depend very much on
signal reception. Reception may be poor in weak signal areas. In this event, either consult your dealer or purchase a commercially available antenna booster. Refer to the antenna booster owner’s manual for installation details.
•Before recording important content, make a trial recording to confirm proper connection and function of your Symbio AVHD recorder. Toshiba is not liable for any damage or loss caused directly or indirectly by the malfunction of the Symbio AVHD recorder, including, without limitation, failure to record content intended to be recorded by the consumer.
•If you attempt to change channels or inputs while a recording
+10
–
ACTION 100 MENU
ENTER
MODE selects the remote control mode. Select ÒTVÓ mode when using the Symbio AVHD recorder.
TV GUIDE opens the TV Guide On Screen system.
TheaterNet DEVICE opens the TheaterNet Device Selection window.
TheaterNet CTRL opens the Stream Selection window.
ENTER
Live returns viewing of the TV back to the live program, while continuing to record to the recording buffer.
SKIP/SEARCH SSand TT skip forward and backward during playback, in increments of the AVHD skip time.
REW – PAUSE – PLAY – FF
STOP – REC
VCR+ opens the TV Guide On Screen manual recording SCHEDULE screen.
LIST displays SymbioÕs play list.
is in progress, the message “NOT AVAILABLE WHILE RECORDING” will appear
•Standard Definition (SD) programming is typically transmitted at 4 to 8 megabits per second, depending on the content and content provider. High Definition (HD) programming is typically transmitted at 19 megabits per second. Although HD programming is higher quality, it may take up more than 3 times as much space on your Symbio’s hard drive as SD programming of the same length.
•The Symbio AVHD recorder uses special hardware and advanced content protection schemes* to securely record and play back, over the
*This device incorporates DTCP (digital transmission content protection) technology licensed by the DTLA (digital transmission licensing administrator).
The unauthorized recording, use, distribution, or revision of television programs, videotapes, DVDs, and other materials is prohibited under the Copyright Laws of the United States and other countries, and may subject you to civil and criminal liability.
10 |
| Copyright © 2004 TOSHIBA CORPORATION. All rights reserved. |
|
| |
10 | 10/19/04, 3:01 PM |
(E) Symbio 160HD4