Installation
Follow these recommendations and precautions and heed all warnings when installing your device.
19)Always provide a minimum of 4 inches (10 cm) of space around all sides of the device to allow proper ventilation.
20)When choosing a location for the device, take into consideration the potential for damage to the device from moisture condensation. Read item 33, “Moisture condensation precautions,” at right.
21)Always place the device on a level surface. Never use the device on a shaky, vibrating, or unstable surface such as a wobbly table or inclined stand. Before installing the device, make sure the surface can bear the weight of the device.
22)CAUTION: Risk of personal injury or serious equipment damage. Never place the device
in a high location. The device may fall, causing personal injury or serious equipment damage.
23)Never place the Symbio AVHD recorder near or above other devices that emit high levels of heat (such as audio receivers or amplifiers). Failure to observe this precaution may cause heat from the other components to rise over the Symbio AVHD recorder and overheat it.
24)If you place the device near a TV, radio, or VCR, the playback picture may become poor and the sound may be distorted, depending on the location of said equipment. In such an event, place the device as far away as possible from the offending equipment.
25)Never stack anything on top of the device.
26)Never cover the ventilation slots in the device’s case.
27)Never expose the device to dripping or splashing or place items such as vases, aquariums, any other item filled with liquid, or candles on top of the device.
28)Never place or store the device in direct sunlight; hot, humid areas; areas subject to excessive dust, oily smoke, or vibration; or locations with temperatures at or below 41°F (5°C). Such conditions may cause the device to malfunction or shorten its service life.
29)Never place the device in an area where the temperature rises or changes rapidly.
30)Always operate this device from a 120 VAC, 60 Hz power source only.
31)Never allow anything to rest on or roll over the power cord, and never place the device where the power cord is subject to wear or abuse.
32)Always place the device horizontally; never install it vertically.
Moisture condensation precautions
33)To prevent damage, never use the Symbio AVHD recorder when moisture condensation appears on the device.
Read the following carefully before installing the device. Moisture condensation can occur in the following situations:
•When you move the device from a cold or air conditioned room to a hot, humid room.
•When you use the device in an area in which the temperature rises or changes rapidly.
•When you place the device in an area in which cold air from an air conditioner directly hits the device.
•When you use the device in a humid area.
Using the device when moisture condensation exists may damage the hard disc drive and other parts, and is deemed misuse. Toshiba is not liable for any damage or loss caused directly or indirectly by such misuse, and any such damage is not covered under the Symbio warranty.
If moisture condensation appears on the device, follow these steps:
a)Unplug the device’s
b)Unplug the device’s power cord from the AC outlet.
c)Place the unplugged device in a dry,
d)Leave the device in the dry,
e)Allow the device to warm up for at least 2 hours.
f)Make sure the device is not returned to an area with conditions as described in the bulleted items above.
Handling
For better performance and safer operation of your device, follow these recommendations and precautions.
34)WARNING: RISK OF ELECTRIC SHOCK! Never spill liquids or push objects of any
kind into the slots in the device’s cabinet. Failure to follow this WARNING may result in death or serious injury.
35)The top of the device may become hot during use. This is normal. Always allow the device to cool before handling it.
36)When handling the device, always hold it horizontally.
37)Never shock or shake the device, especially during operation. Doing so may cause malfunction.
38)Never disconnect the power cord from a wall outlet while the device is recording or playing (unless it is an emergency). Before disconnecting the power cord, close all AVHD functions on the TV and make sure the REC and PLAY LEDs on the device’s front panel are NOT illuminated. Unplugging the power cord during recording or playback operation may cause malfunction or equipment damage.
39)For added protection of your device from lightning and power surges, always unplug the power cord if you leave the device unattended or unused for long periods of time.
40)Never use volatile compounds (such as insecticide) near the device, and never leave rubber or plastic products in contact with the device for long periods of time. Doing so may leave marks on the finish.
41)When shipping the device, it is recommended that you use the original shipping carton and packing materials. For maximum protection, repack the device as it was originally packed at the factory.
(Continued on next page)
3
3 | 10/19/04, 3:03 PM |
Symbio AVHD recorder 160HD4