INSTALLATION
English
Mains
The type plate is located on the rear of the set.
1Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult your dealer or service organisation.
2Make sure all connections have been made before switching on the mains supply.
3Connect the mains cable supplied to AC MAINS ~ and to the wall socket. This switches on the mains supply.
For optimal performance use only the original mains cable.
When the set is switched to standby, it is still consuming some power. To disconnect the set from the mains completely, remove the mains plug from the wall socket.
For users in the U.K.: please follow the instructions on page 2.
To avoid overheating of the set a safety circuit has been built in. Therefore your set may disconnect under extreme conditions. If this happens, switch the set off and let it cool down before reusing it.
Speaker connections
The speaker connections are
Antenna connections
AM antenna
The loop antenna supplied is for indoor use only.
1Fit the plug of the loop antenna to AM AERIAL as shown below.
2Position the antenna as far away as possible from the TV, a VCR and other radiation sources.
3Turn the antenna for optimum reception.
AM | AERIAL |
|
FM antenna
The wire antenna supplied can only be used to receive nearby stations. For better reception we recommend using a cable antenna system or an outdoor antenna.
1Fit the supplied wire antenna to FM AERIAL 75 Ω as shown below.
2Move the antenna in different positions for optimum reception.
•If you are using a cable antenna system or an outdoor antenna, fit the antenna plug to FM AERIAL 75 Ω instead
of the wire antenna.
1Connect the coloured (or marked) wire to the red terminal and the black (or unmarked) wire to the black terminal.
2Connect:
–Left speaker to L (red and black)
–Right speaker to R (red and black)
FM | AERIAL | 75 | Ω |
| |||
|
|
FM | AERIAL | 75 | Ω |
| |||
|
| ||
|
|
|
8