Heat Controller MSS-009B/A Insert the connecting cable into the indoor unit, Cable, On the wrench

0

	5. Insert the connecting cable into the indoor unit
	" Don't conned the cable to the indoor unit.
	" Make a small loop with the cable for easy connection
	later.
	6. Tape the tubing, drain hose and the connecting
	cable.
	7. Indoor unit installation
	" Hook the indoor unit onto the upper portion of
	installation plate. (Engage the two hooks of the rear
	top of the indoor unit with the upper edge of the
	installation plate.)
	Ensure the hooks are property seated on the
	installation plate by moving it in left and right.
	B. Connecting the pipings to the indoor unit.
	" Align the center of the pipings and sufficiently tighten
	the flare nut with fingers.
"	" Finally, tighten the flare nut with torque wrench until
	the wrench clicks.
	When tightening the flare nut with torque wrench,

Indoorloutdoor connecting cable

Taping
	as side piping
Connecting	Liquid side piping
cable
	Drain hose

-fir---r

ýJý"'ýL7

ensure the direction for tightening follows the arrow

on the wrench.

Indoor unit tubing

V Flare nut Pipings

	Pipe Size	Torque
gK Liquid Side (1/4")		1.8kg"m(13ft.lbs)
12k	Gas Side (112")	5.5kg"m(39.8ft.ibs)
18k, Liquid Side (a18")		4.2kg"m(28.9ft.lbs)
24k	Gas Side (5/8")	6.6kg"m(47.7ft.lbs)

Spannerwrench -Torque

AA

8.Wrap the Insulation material around the connecting portion-

CAUTION: Take care to arrange the pipings, drain hose and cables as the right upper picture for Inserting it Into the indoor unit and refixing the tubing holder easily.

Plastic Bands Insulation material

Wrap the insulation material around the connecting portion.

-31-