Philips DTB297 Listen to radio, Store DAB radio stations automatically, Basic operations

5 Listen to radio

Note

•• For optimal reception, fully extend the antenna and adjust its position, or connect an outdoor antenna.

•• This product does not support MW (medium wave) radio reception.

•• You can program a maximum of 20 DAB radio stations and 20 FM radio stations.

•• Check with local retailer or go to www.WorldDAB.org for the applicable DAB radio frequencies in your area.

•• Refer to "Product information" > "RDS program types" for more information about RDS radio stations.

Store DAB radio stations automatically

If no DAB radio station is stored, this product can search and store DAB radio stations automatically.

1Press SOURCE repeatedly to select the DAB source.

»»[FULL SCAN] (full scan) scrolls on the display panel.

2Press OK/ to start auto installation.

»»This product automatically stores DAB radio stations with sufficient signal strength.

»»After all available DAB radio stations are stored, the first stored DAB radio station is broadcast automatically.

Basic operations

Follow the instructions below for more functions.

Tune to the next FM radio station with sufficient signal strength at the lower/higher frequency:

Press and hold TUNING +/- / to start auto search.

Tune to the FM radio station at a specific frequency:

Press TUNING +/- / repeatedly until the frequency digitals are displayed.

Program FM radio stations automatically:

Press SCAN/PROG/ to start auto programming.

Program DAB radio stations automatically:

Press SCAN/PROG/ to start auto scanning and programming.

Program radio stations manually:

1)Tune to a radio station.

2)Press and hold SCAN/PROG/ to activate programming.

3)Press PRESET +/- / to assign a sequence number to the radio station.

4)Press OK/ to confirm.

5)Repeat steps 1-4 to program more radio stations.

Tune to a preset radio station:

Press PRESET +/- / repeatedly.

Switch the audio mode between [STEREO] (stereo) and [MONO] (monophonic) for FM radio:

Press OK/ repeatedly.

Display available information about the current radio station:

Press MENU/INFO/SET TIME/ repeatedly.

Use the menu

When you listen to radio, you can access the menu for control options.

1Press and hold MENU/INFO/SET TIME/ .

»»FM mode: [SCAN] (scan) is displayed.

»»DAB mode: [FULL SCAN] (full scan) is displayed.

2Press TUNING +/- / to select a

menu option, and then press OK/ to confirm the option or enter the lower-level menu.

12EN