Philips DS9800W Troubleshooting, Remote control does not work, FhuwlàhgPdnhVxuhWrHqdeohWkh

9 Troubleshooting

Warning

‡Never remove the casing of this apparatus.

To keep the warranty valid, never try to repair the system yourself.

If you encounter problems when using this apparatus, check the following points before

UHTXHVWLQJVHUYLFH,IWKHSUREOHPUHPDLQV unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.

No power

‡Make sure that the AC power plug of the device is connected properly.

‡Make sure that there is power at the AC outlet.

No sound

‡Adjust the volume.

‡Check the network connection. Set up the network again if needed (see 'Connect to your home Wi-Fi network for AirPlay' on page 12).

‡Check if you have selected the correct audio source.

No response from the unit

‡Press and hold on DS9800W for more than 5 seconds to reset the device.Then set up the Wi-Fi network for DS9800W again (see 'Connect to your home Wi-Fi network for AirPlay' on page 12).

‡Disconnect and reconnect the AC power plug, and then switch on the device again.

Remote control does not work

‡%HIRUH\RXSUHVVDQ\IXQFWLRQEXWWRQÀUVW select the correct source with the remote control instead of the main unit.

‡Reduce the distance between the remote control and the unit.

‡Insert the battery with its polarities (+/– signs) aligned as indicated.

‡Replace the battery.

‡Aim the remote control directly at the IR sensor on the front of the main speaker.

Wi-Fi network connection failed

‡Check if your Wi-Fi router is Wi-Fi 802.11b/g

FHUWLÀHG7KLVGHYLFHLVRQO\FRPSDWLEOHZLWK :L)LEJFHUWLÀHGURXWHUV

‡If your Wi-Fi router is Wi-Fi 802.11n

FHUWLÀHGPDNHVXUHWRHQDEOHWKH

802.11b/g mode. DS9800W does not support connection to routers with 802.11n only.

‡This device does not support the WPS- PIN method.

‡If your Wi-Fi router supports WPS and the WPS-PBC method but fails to connect to DS9800W, try the manual Wi-Fi setup method (see 'Scenario 2: Connect to a non-WPS router' on page 13).

‡Enable SSID broadcast on the Wi-Fi router.

‡Keep away from potential sources of interference which may affect Wi-Fi signal, such as microwave ovens.

‡If you fail to use your PC for Wi-Fi network setup, check whether your PC is using a Wi-Fi network.You cannot use Ethernet connection for AirPlay network setup.

‡Make sure that the SSID name of your home router consists of alphanumeric characters, with no space or special characters like %/#/* inserted.

‡If you choose to rename the AirPlay device 'Philips_Fidelio XXXX' in the setting menu, do not use special characters or symbols.

‡For some new types of Wi-Fi routers, a network name (SSID) may be created automatically when you use WPS for connection. Always change the default network name (SSID) to a simple one that consists of alphanumerical characters, and also change the Wi-Fi security mode to secure your network.

EN 27