Philips AX3315, AX3312, AX3311 quick start Controls / Power Supply

Page 3

English

CONTROLS / POWER SUPPLY

POWER SUPPLY / GENERAL INFORMATION

Controls ( see figure 1 )

1LINE OUT/p........3.5 mm headphone socket, socket to connect the player to another audio input of an additional appliance

2

skips and searches CD tracks backwards

3

9

stops CD play, clears a program or switches the player off

4

§

skips and searches CD tracks forwards

5

2;

switches the player on, starts or pauses CD play

6 PROG

programs tracks and reviews the program

7 MODE

selects the different playing possibilities: shuffle,

 

 

shuffle repeat all, repeat, repeat all and SCAN

8............................display

9 DBB

switches the bass enhancement on and off. This button also

 

switches acoustic feedback (the beep) on/off when it is

 

pressed for more than 2 seconds

0 VOL −/+

adjusts the volume

! 4.5V DC

socket for external power supply

@ OPEN 2

opens the CD lid

# ESP ON /

 

POWER SAVE

to select between the battery powersave mode and

 

Electronic Skip Protection (ESP). ESP ensures continuous

 

CD playback regardless of vibrations and shocks

$ OFF

switches RESUME and HOLD off

RESUME

stores the last position of a CD track played

HOLD

locks all buttons

%............................typeplate

^............................battery compartment

&............................AAA battery door

Batteries (supplied or optionally available)

For convenience, this model is designed with 2 different detachable battery doors. This allows you to operate the player using 2 choices of battery size. You can use the following batteries with this CD-player:

alkaline batteries type AAA (LR03, UM4) or AA (LR6, UM3) preferably Philips.

Notes:– Old and new or different types of batteries should not be combined.

Remove batteries if they are empty or if the player is not going to be used for a long time.

1

Inserting AAA (LR03, UM4) or AY 3363 batteries

+

+

Open the AAA battery door.

LR03/AAA

 

 

/UM4

2

Insert AAA batteries as shown onto the back of the

-

 

 

door.

 

 

3

Replace the battery-loaded AAA door back onto the

AAA (LR03, UM4)

 

 

set.

 

 

 

 

Average playing time of batteries under normal conditions

Battery type

ESP on

Power Save

Alkaline AA

15 hours

20 hours

Alkaline AAA

 

7 hours

9 hours

Rechargeable ECO-PLUS NiMH battery

3 hours

5 hours

Batteries contain chemical substances, so they should be disposed of properly.

ECO-PLUS NiMH battery information (for versions supplied with the

rechargeable ECO-PLUS NiMH battery AY 3363)

Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3363.

Recharging the ECO-PLUS NiMH battery on board

1Insert the rechargeable ECO-PLUS NiMH battery AY 3363.

2Connect the mains adapter to the 4.5V DC socket of the player and then to the wall socket.

y is pulsing.

Recharging stops after a maximum of 7 hours, or when you start playback.

3 When the battery is fully recharged, FULL appears in the display.

Notes: – It is normal for the batteries to become warm during recharging.

If the batteries become too warm, recharging will be interrupted for approximately 30 minutes .

To ensure proper recharging on board, take care that contacts are clean.

Use only the ECO-PLUS NiMH battery AY 3363.

Handling instructions

Recharging already charged or half-charged batteries will shorten their lifetime. We therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it.

To avoid a short circuit, do not let the battery touch any metal object.

If the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime.

Mains adapter (supplied or optionally available)

Use only the AY 3170 adapter (4.5 V / 300 mA direct current, positive pole to the center pin). Any other product may damage the player.

1 Make sure the local voltage corresponds to the power

4.5V DC

 

adapter’s voltage.

 

Inserting AA (LR6, UM3) batteries

To double playback time, insert AA batteries into the battery compartment and use the AA marked battery door.

Open the battery compartment and insert either 2 normal or alkaline batteries.

Battery indication

+

-

 

-

+

AA SIZE

 

 

LR6

/ UM3

 

 

AA (LR6, UM3)

2Connect the power adapter to the 4.5V DC socket of the player and to the wall socket.

Note: Always disconnect the adapter when you are not using it.

Environmental information

The approximate power level of your batteries is shown in the display. Battery full

Battery two-thirds full

Battery one-third full

Battery dead or empty. When the batteries are

dead or empty, the symbol flashes, bAtt is displayed, and the beep tone sounds repeatedly.

All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into two mono materials: cardboard (box) and polyethylene (bags, protective foam sheet).

Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.

Image 3
Contents Portable CD Player English Need help? Call usHold OFF Play VOL Limited Warranty EL 6474-E004 02/8Use only with a cart, stand, tripod, bracket, or table Controls / Power Supply CD Play Battery, negative grounding, then connectPress DBB to switch the bass enhancement on or General InformationSwitch the slider to Hold to activate Hold FeaturesWarranty Owner Model Verification Confirmation Registration Troubleshooting