Philips AJ3136 Controls see, Alarm Reset / Sleep, @ Repeat Alarmbrightness Control, Power Supply

Page 9

English

CONTROLS (see 1)

1ALARM RESET / SLEEP

-stops active alarm for 24 hours

-activates the radio for sleep function, and to select the sleep time

2ALARM ON / OFF : switches alarm ON and OFF

3RADIO ON / OFF - switches radio ON and OFF

4Pigtail aerial - antenna for FM reception

5SET AL / TIME- sets the clock and alarm time

6MIN + : - adjusts the minutes for clock and alarm times

7HOUR + : adjusts the hours for clock and alarm times

8Battery door - opens to store a 4 x R6/UM3/AA batteries (not included)

9RESET - press if the set / display does not react to operation of any button

0VOLUME - adjusts the sound level

!TUNING - tunes to radio stations

@REPEAT ALARM•BRIGHTNESS CONTROL

-switches off the alarm for a 5 minute period

-changes display illumination brightness

-stops SLEEP function

#Display - shows clock and alarm times and status

The model and serial number are located inside the battery

POWER SUPPLY

Batteries (not included)

1Open battery door and insert four batteries (preferably PHILIPS POWER LIFE or alkaline), type R6, UM3 or AA as indicated in the compartment.

2Remove the batteries from the set if they are exhausted or not be used for a

long time.

When the batteries are turning low, appears in the display. The radio and backlight will not function, but the display and power saving buzzer will continue to operate.

When replacing batteries, the clock time and alarm setting will be stored by the self-powered back-up for 1 minute (see 'Self-Powered Back-Up').

Make sure the radio is switched off to save battery energy.

Batteries contain chemical substances, so they should be disposed of properly.

SELF-POWERED BACK-UP

The self-powered back-up conveniently allows your clock and alarm settings to be stored for up to 1 minute when there is a power interruption e.g. AC power failure or when changing batteries.

The complete clock radio and backlight illumination will be switched off. As soon as the power supply returns the display will indicate the correct time.

If power supply returns after 1 minute, the demo mode appears and you will need to re-enter the clock and alarm setting.

compartment.

Image 9
Contents Clock Radio Philips Consumer Electronics North America Page Alarm Alarm Alarm Safety Important Safety Instructions What is EXCLUDED? WHO is COVERED? What is COVERED?Where is Exchange AVAILABLE? Before Requesting ExchangeExchanging a Product in Canada RememberPhilips, P.O. Box 520890, Miami, FL 33152, USA, 402 @ Repeat Alarmbrightness Control Alarm Reset / SleepPower Supply SELF-POWERED BACK-UPBattery LOW Mode Setting the Clock and Alarm TimesGeneral Features 24HR Alarm Reset Using the AlarmRepeat Alarm Canceling the Alarm CompletelyMaintenance TroubleshootingEnviromental Information