Philips 7101, AX7104 warranty Controls / Power Supply, Power Supply / General Information

	English		CONTROLS / POWER SUPPLY
	CONTROLS ( see figure 1 )
1 OPEN 2			opens the CD lid
2		2;	switches the player on, starts or pauses CD play
3		9	stops CD play, clears a program or switches the player off
4		§	skips and searches CD tracks forwards
5 ESP			EXTREME SHOCK PROTECTION ensures continuous CD
			playback regardless of vibrations and shocks
6 MODE			selects the different playing possibilities: SHUFFLE,
			SHUFFLE REPEAT ALL, REPEAT, REPEAT ALL and SCAN

7............................display

8 PROGRAM	..........programs tracks and reviews the program
9 BASS	switches the bass enhancement on and off. This button also
	switches acoustic feedback (the beep) on/off when it is
	pressed for more than 2 seconds
0 ∞	skips and searches CD tracks backwards
! RESUME	stores the last position of a CD track played
HOLD	locks all buttons
OFF	switches RESUME and HOLD off

@LINE OUT/p........3.5 mm headphone jack and LINE OUT jack to connect the player to another audio input of an additional appliance, remote control jack (not on all versions)

#VOL E ............adjusts the volume

$ 4.5V DC ...............jack for external power supply

%............................belt clip holder

^............................type plate

POWER SUPPLY / GENERAL INFORMATION

Mains adapter (supplied or optionally available)

Use only the AY 3170 adapter (4.5 V / 300 mA direct current, positive pole to the center pin). Any other product may damage the player.

1 Make sure the local voltage corresponds to the power adapter’s voltage.

2Connect the power adapter to the 4.5V DC jack of the player and to the wall outlet.

Note: Always disconnect the adapter when you are not using it.

Environmental information

•All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into two materials: cardboard (box) and polyethylene (bags, protective foam sheet).

•Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment.

Batteries (supplied or optionally available)

You can use the following batteries with this CD-player:

•normal batteries type LR6, UM3 or AA (preferably Philips), or

•alkaline batteries type LR6, UM3 or AA (preferably Philips).

Notes:– Old and new or different types of batteries should not be combined.

–Remove batteries if they are empty or if the player is not going to be used for a long time.

Inserting batteries

1 Push OPEN 2 to open the CD lid.

2 Open the battery compartment and insert either 2 normal or alkaline batteries.

Battery indication

The approximate power level of your batteries is shown in the display.

Battery full

Battery two-thirds full

Battery one-third full

Battery dead or empty. When the batteries are dead or empty, the symbol A flashes,

bAtt is displayed, and the beep tone sounds repeatedly.

Average playing time of batteries under normal conditions

Battery type	ESP on	Power Save
Normal	5 hours	6 hours
Alkaline	22 hours	25 hours

Batteries contain chemical substances, so they should be disposed of properly.

CD player and CD handling

• Do not touch the lens A of the CD player.

• Do not expose the unit, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight).

• You can clean the CD player with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect.

•To clean the CD, wipe it in a straight line from the center toward the edge using a soft, lint-free cloth. A

cleaning agent may damage the disc! Never write on a CD or attach a sticker to it.

•The lens may cloud over when the unit is moved suddenly from cold to warm surroundings. Playing a CD is not possible then. Leave the CD player in a warm environment until the moisture has evaporated.

•Active mobile phones in the vicinity of the CD player may cause malfunctions.

•Avoid dropping the unit as this may cause damage.

Headphones HL351

• Connect the supplied headphones to the LINE OUT/p jack of the player.

Note: LINE OUT/pcan also be used for connecting the player to your HiFi system (with a signal lead) or to your car radio (with a cassette adapter or signal lead). In both cases, the volume of the player must be set to position 8.

IMPORTANT!

Hearing safety: Do not play your headphones at a high volume. Hearing experts advise that continuous use at high volume can permanently damage your hearing.

Traffic safety: Do not use headphones while driving a vehicle. It may create a hazard and it is illegal in many countries. Even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high that you cannot hear what is going on around you.