Philips 1 manual Operation Display and picture control, Activate Pan

8. Operation Display and picture control

Note: A(audio)/V(video)-mutecan only be selected with the AV mute button on the projector or on the remote control. A/V mute then appears on the screen.

For example:

Data

Shift

The Shift function adjusts the computer image in horizontal and vertical direction to center it on the screen. This function is only active when Auto image is set to OFF.

A/V Muted

1.Press Menu.

–The menu bar appears on the screen. Display is highlighted and its sub menu is shown.

2.Use Cursor Control to move the cursor to Shift.

3.Press OK (–/––) to activate Shift.

Display Picture Audio Settings

Digital Freeze

Digital Zoom

Magnification

Pan

Keystone correction

Auto Image

Horizontal size

Phase

Shift

The following adjustments procedures follow a slightly different sequence of actions, or may need some further explanation.

Pan

To view an enlarged area of the projected picture the Pan function is used. Panning is only possible when the picture is enlarged with Digital Zoom. If the picture is not enlarged, the panning option is greyed out. When the Digital Zoom is active, the Cursor Control gives direct access to the Panning function.

1.Press D(igital) Zoom to activate the Digital Zoom function.

2.Press Menu.

–The menu bar will appear.

Display is highlighted and its sub menu is shown.

3.Select the required zoom factor under Magnification.

4.Use Cursor Control to move the cursor to Pan.

5.Press OK (–/––) to

activate Pan.
	Panning

4.Use Cursor Control to position the computer image.

5.Press OK (–/––) to confirm and store the adjustment.

6.If required, select the next item to be adjusted or press MENU to exit.

Shift is used to adjust the position of the image. Confirm to activate Shift.

Shift

Move pointer to position the image.

Press OK key when done.

6.Use Cursor Control to pan left, right, up or down.

7.Press MENU to exit.

Move pointer to select the area to be enlarged.

Press OK key when done.

Auto image

The auto image function automatically sizes and positions the image to fit optimally in the screen picture. In addition it takes care for phase adjustment. It does not affect the selected picture format. When Auto image is set to ON, the Horizontal size, Shift and Phase options are greyed out.

Horizontal size

The Horizontal size function is used to size a computer image to make it fit the projected picture. The horizontal size parameter has permanent scope. When the OSD menu is active and the horizontal size option is selected, the level will be indicated graphically on a linear scale (gauge). The default output level conforms to the value set by the Auto image function. Switching to another data mode automatically restores Auto image if the data mode is not part of the ten most recently used display modes.

17