Installation Procedure
Connect the wires of swing flap motor on the ornament panel.
Connect the signal wires.
Check if the remote controlling is avalible, |
|
if not,please check if all the connecting of | Electrical box |
wires is right.Turn off the power for ten | |
seconds,and then try it again. |
|
remote receiver | Emergency switch |
Pay special care to the following and check after installation
Item to the checked
Unproper installation may cause
Check
Is indoor unit firmly installed? | Unit might fall down, make vibration or noise. |
|
|
|
|
Is gas leakage check performed? | This may lead to gas shortage. |
|
|
|
|
Is unit properly insulated? | Dew or water drop may occur. |
|
|
|
|
Is water drainage smooth? | Dew or water drop may occur. |
|
|
|
|
Is power voltage meet that stipulated on the nameplate? | Problem may occur or parts got burned. |
|
|
|
|
Is wiring and piping correctly arranged? | Problem may occur or parts got burned. |
|
|
|
|
Is unit safely grounded? | There might be a danger of electric shock. |
|
|
|
|
Is wire size correct? | Problem may occur or parts got burned. |
|
|
|
|
Are there any obstacles on air inlet and outlet grill of | This may cause poor cooling. |
|
indoor and outdoor unit? |
|
|
|
|
|
Is record made for piping length and refrigerant | It is hard to control refrigerant charging |
|
charging amount? | amount. |
|
|
|
|
22