Installed Key
Figure 4. Properly installed key.
3.Carefully lift the fence assembly onto the fence base support. Make sure that the key is fully seated into the key way. Avoid letting the fence slide across the jointer tables.
4.Slide the lock handle shaft through the flat washer and into the slot on the top of the fence assembly base. Thread the slide piece onto the end of the lock knob shaft as shown in Figure 5.
5.Thread the fence adjustment handle into the tapped hole on the top edge of the fence.
6.With the lock knob loose, the fence assembly should slide smoothly across the key way. Avoid letting the fence drag across the tables.
Figure 5. Fence base lock knob attachment.
Cutterhead Guard
The cutterhead guard spring tension comes pre- set from the factory. To install the cutterhead guard:
1.Loosen the black plastic knob shown in Figure 6.
2.Slide the cutterhead assembly post into the slot shown in Figure 6.
3.Tighten the black plastic knob that was loos- ened in Step 1.
4.When rotated, make sure the cutterhead guard rotates back over the cutterhead assembly.
Figure 6a. Attaching cutterhead guard.
|
|
|
|
|
|
|
|
|
| Ultimate Series Jointers | |
|
|