SECTION 4: ASSEMBLY
Beginning Assembly
! | Disconnect power to the | |||
machine when perform- | ||||
ing | any | maintenance, | ||
| assembly | or | adjust- | |
| ments. Failure to do this | |||
| may | result in | serious | |
| personal injury. |
|
Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.
Wear safety glasses during the entire assem- bly process. Failure to comply may result in serious personal injury.
Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.
Most of your Ultimate Series Jointer has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: You will need a high quality square, 45° angle gauge, a long straightedge, 11/13mm open end wrench, and a 8, 6, 5, 4 and 3mm Allen® wrench.
Ultimate Series Jointers
Fence
NOTICE
DO NOT slide the fence across the outfeed table. Scratching will result.
To install the fence assembly:
1.Using (2)
2.Make sure the 10 x 8 x 260mm key is fitted into the key way on the fence base support as shown in Figure 4.
The fence assembly is a heavy part. Seek assistance when lifting it onto the fence base support.
Fence Base Support