45° Fence Stop
1.Place a 45° gauge on the outfeed table fair- ly close to the cutterhead as shown in Figure 16.
Figure 16. Using a 45° gauge to align fence.
2.While holding the fence adjusting handle, loosen the angle setting lock knob and the checknut on the 45° stop screw as shown in Figure 17. Turn the stop screw against the sliding bracket until the fence contacts the edge of the 45° gauge evenly.
3.Tighten the checknut on the stop screw and tilt the fence forward, then back against the stop.
4.Recheck with the 45° gauge. Tightening the checknut will move the stop bolt slightly, so some trial-and-error may be necessary to perfect your settings.
45° Stop
Figure 17. Setting the 45° stop.
Ultimate Series Jointers |