DS5 | User Guide |
Drive Assembly - DS5
If your setup requires an internal drive, open the case and install a hard drive before turning the unit on.
Note: Format the drive using FAT32 before installing it.
2.5” HDD or CF card
1.Lift the top cover off the body.
2.Take the drive module and insert your CF card or the 2.5” HDD. Note: The
DS5 can not work with a CF card AND hard drive installed together!
4.Align the drive module with your DS5 and push it lightly into place, so that the connector from your module fits into the IDE connector on the DS5 bridge board. Mount it with the 4 screws as seen in the illustration below.
3.If your are installing the 2.5” HDD, mount it with two screws from beneath.
5.Align the top cover with the body and push lightly into place.
Note: Be careful not to damage any cables or components during the installation!
Page 9 / Chapter 2 - Hardware Installation
