AMX manual Connecting a USB Keyboard and Mouse to the MVP-TDS

Page 10

MVP-TDS Table Top Docking Station

Once MVP batteries are fully charged, the MVP-TDS begins charging MVP-BP batteries inserted within its rear battery compartments. Initially, both blue LEDs illuminate and remain dim (indicating that the power is being supplied to the MVP-TDS).

Connecting a USB Keyboard and Mouse to the MVP-TDS

The MVP-TDS can have two USB input devices (keyboard and mouse) connected for use on the MVP panel’s different firmware and TPD4 panel pages. These input devices can consist of a keyboard and mouse.

USB input devices are detected by the docking stations only after they are connected and then power is applied.

1.Remove the power connector from the docking station.

2.Insert the USB connectors of the peripheral input devices, into the appropriate USB connector on the docking station.

3.Reconnect the terminal power connector to the docking station and apply power.

4.Install the MVP panel onto the docking station.

5.Navigate to the Protected Setup page on the MVP panel and press the Reboot button to restart the panel. This step allows the MVP panel to detect the USB input devices signals being sent through the connected docking station.

The MVP does not recognize the keyboard and/or mouse (connected to the docking station) until after the MVP itself has been rebooted.

It does not matter if the MVP is on the docking station at the time the USB devices are plugged in or not.

The reboot of the panel has to occur after the MVP is properly connected and communicating with the docking station. In addition, if the MVP is removed from the docking station, the panel will not recognize the keyboard and/or mouse after it is put back on the docking station - the MVP will have to be rebooted again.

6.After the panel splash-screen disappears:

If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location corresponds to the mouse cursor position sent by the external USB mouse.

If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any external keystrokes sent from the external USB keyboard.

To be detected by the docking station, USB input devices (keyboard / mouse) must be plugged into the docking station before it is powered-up. The docking station will not detect USB input devices until the unit cycles power.

4

MVP-TDS Table Docking Station for MVP Panels

Page 9 Page 11
Image 10
Page 9 Page 11
Contents MVP-TDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Specifications OverviewMVP-TDS docking station connectors Front Panel ComponentsMVP-TDS LED Indicators InstallationConnecting a Power Supply Interface Connector Pins and FunctionsConnecting a USB Keyboard and Mouse to the MVP-TDS After the panel splash-screen disappearsSecuring an MVP Panel to an MVP-TDS System message panel is properly dockedUnsecured MVP removal from an MVP-TDS Installing and Charging Batteries in the Docking StationsRemoving an MVP Panel from an MVP-TDS Secured MVP removal from an MVP-TDSInstalling an MVP-BP Battery into an MVP-TDS Page Upgrading the Docking Station Firmware Prepare the Docking Station for firmware transfer via USBUpgrade the Docking Station firmware via USB BatteriesDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control
Top Page Image Contents