AMX manual Securing an MVP Panel to an MVP-TDS, System message panel is properly docked

MVP-TDS Table Top Docking Station

Securing an MVP Panel to an MVP-TDS

The MVP will not be able to communicate with or receive power from the MVP-TDS without a proper connection.

1.Place the MVP-TDS on a flat and level surface.

2.Provide power to the MVP-TDS (refer to the Powering the MVP-TDSsection on page 3).

3.Place the MVP on the support cradle so that the alignment pins on the TDS fit into the matching holes on the bottom of the MVP.

4.Once proper alignment is verified, gently angle back the MVP until the rear of the panel makes contact with the electromagnet. Allow one second to activate the electromagnet.

When the MVP is properly docked, the following message is displayed on the panel (FIG. 4).

On-screen Docking message

Docking Status button (illuminates to also give an indication that the panel is properly docked)

FIG. 4 System message - panel is properly docked

Proper docking and communication can be verified via the on-screen system message, or the illuminated Docking Status button on the Protect Setup page, or the right LED on the docking station.

If the MVP is docked properly and communicating, the right LED on the MVP-TDS will remain brightly illuminated.

Refer to the LED Pattern Indicators for the MVP-TDS table on page 3 for more information.

If the panel is not securely attached, the electromagnet on the TDS will not be activated, and the panel could fall forward and be damaged.

MVP-TDS Table Docking Station for MVP Panels 5